Kwikset Powerbolt 2 Touchpad Keyless Entry

Programming Instructions

This document provides step-by-step instructions for programming the Kwikset Powerbolt 2 Touchpad Keyless Entry lock. It covers resetting the lock, setting the locking and unlocking direction, testing the lock, deleting user codes, and changing the default mastercode.

A User Code is used to unlock the door, while a Mastercode is a password for making changes to the lock features.

Getting Started

Before programming, ensure your lock is ready. The first step involves resetting the lock to its original settings.

Step 1: Reset Your Lock

Follow these steps to reset your lock:

1. Ensure the lock is in the unlocked position.
2. Remove the battery cover.
3. Press and hold the "Reset" button for 5 seconds. You will hear three long beeps, indicating the lock has been reset.

Tip: After a reset, your User Code will be 1-2-3-4 and your Mastercode will be 0-0-0-0.

Step 2: Set Locking and Unlocking Direction

1. Make sure the door is open and in the unlocked position.
2. Press the default Mastercode (0-0-0-0) and the Kwikset button.

Note: Each button represents two numbers. If you enter the code incorrectly, wait 10 seconds before trying again.

Tip: The keypad may or may not light up orange during this step. Continue to complete the step.

Upon successful completion, the latch bolt will extend and retract fully.

Tip: A successful step is indicated by two beeps and a green flashing keypad.

Step 3: Test the Lock

1. Ensure the door is open and in the unlocked position.
2. Press the default Mastercode (0-0-0-0) and the Kwikset button. The latch will extend fully and the keypad will turn off.
3. Enter your User Code (1-2-3-4) and the Kwikset button. The latch will retract fully, and the keypad will turn off.

Step 4: Delete All User Codes

1. Ensure the door is open and in the unlocked position.
2. Enter the default Master Code (0-0-0-0-5) and the Kwikset button.

The lock will beep twice and the keypad will flash green.

Step 5: Program User Codes

1. Ensure the door is open and in the unlocked position.
2. Enter the default Master Code (0-0-0-0-1) and the Kwikset button.
3. Enter a 4 to 10 digit User Code and press the Kwikset button.

The lock will beep twice and the keypad will flash green.

Step 6: Change the Default Mastercode

1. Ensure the door is open and in the unlocked position.
2. Enter the default Master Code (0-0-0-0-7) and the Kwikset button.
3. Enter a new 4 to 10 digit code and press the Kwikset button.

The lock will beep twice and the keypad will flash green.

For further assistance, contact Kwikset support at 1-800-327-LOCK (5625).