my Touch Smart timer Plug-in Timer User Manual
Mounting/Installation
- Mount the timer on a wall near a GFCI receptacle using a screw or nail. Timer must be mounted in a vertical position with the outlets facing downwards at least 4ft. above ground level. Screw or nail head must extend at least 3/16″ out from the wall (nails or screws not included).
- Hang the timer, from the hole at the top of the unit.
Setup
If no numbers are visible on-screen, plug timer into an outlet and let timer charge for 1 hour. Once charged, press the reset ( 0) button in the lower ri ht corner using a toothpick or pencil.
Set the time
Use up ( l::,.) and down ( ‘v) arrows to set current time, take note of AM or PM time.
Programming Options
Set your custom on & off time and/or pick any of the presets that suit your schedule!
Preset schedules
There are 3 pre-programmed times that run individually or simultaneously. Choose from the following:
- “evening” (Spm-12am)
- “morning” (Sam-Sam)
- “all night” (6pm-6am).
When a preset or custom program is chosen, the blue LED indicator light will turn on. If a preset schedule does not fit your needs, a custom on/off time can be used to modify the preset. Example: Using “evening” (Spm-12am) and adding a “my off
time” of
Choose your custom on
Press “my on time,” then use up ( l::,.) and down ( ‘v) arrows to set on time. Press “my off time,” then use up ( t::. ) and down ( ‘v) arrows to set off time. (If you set the “my on time” earlier than the current time, it will not turn on until the next day at the time scheduled. Use the Countdown to turn on the timer if needed immediately.) When using “my on” and “my off” times make sure the blue light is lit next to the button. The blue lights will only illuminate when plugged into a wall outlet.
Countdown
This feature turns the light on for a set period of time and turns it off when time expires. Press “countdown,” then use up and down arrows to set from 1 minute to 24 hours. Once you reach your desired time setting, simply walk away and the timer will begin counting down. Your last time setting will be remembered the next time you use the countdown feature.
Note: When daylight savings time occurs use the up and down arrows to adjust the time by 1 hour.
