DROP Embedding Flange
DROP 
Embedding Flange
- Place the plates of embedding flange on the desired place of the boarding. Make sure that the end edges of the embedding flange are against the wall.
- Mark the inner edge of the embedding flange on the boarding of the sauna platform.
- Follow the marked line and draw the second contour 52 mm / 2 in outwards. We recommend using a 52 mm / 2 in wide wooden block for that purpose.
- Cut the wider contour by following the aperture.
- Attach the brackets of the embedding flange to the plates by using bolts and nuts.
- Install the embedding flange to the cut aperture, adjust the cut edge, if necessary.
- Attach the brackets to the boards of the platform with screws.
- You can now install the DROP heater. Follow the minimum height from the figure below:
Find the latest updates on our website www.huumsauna.com
Made in Estonia, EU
info@huumsauna.com
huumsauna.com
#huumsauna
HUUM Sauna OÜ Vahi tee 9, Tartumaa 60534, Estonia
Documents / Resources
 |
HUUM DROP Embedding Flange [pdf] User Manual H300102L03, DROP Embedding Flange, DROP, Embedding Flange, Flange |
