HUUM 16204 Drop Embedding Flange
Installation
Dimension
EMBEDDING FLANGE
- Place the plates of embedding flange on the desired place of the boarding. Make sure that the end edges of the embedding flange are against the wall.
- Mark the inner edge of the embedding flange on the boarding of the sauna platform.
- Follow the marked line and draw the second contour 52 mm outwards. We recommend using a 52 mm wide wooden block for that purpose.
- Cut the wider contour by following the aperture.
- Attach the brackets of the embedding flange to the plates by using bolts and nuts.
- Install the embedding flange to the cut aperture, adjust the cut edge, if necessary.
- Attach the brackets to the boards of the platform with screws.
- You can now install the DROP heater. Follow the minimum height from the figure below:
#huumsauna
www.huum.eu
Documents / Resources
![]() |
HUUM 16204 Drop Embedding Flange [pdf] User Manual 16204 Drop Embedding Flange, 16204, Drop Embedding Flange, Embedding Flange, Flange |