Unscrew two back panel hex bolts and remove the back
panel.
Insert your SIM card into the SIM socket and attach the panel.
Tighten the hex bolts securely. (Adapter not included)

Negara LED

xcom 232i:

Red: On – Update error or backup

Green: Blink – Updating process; Blink 2x – Micro SD full
Orange: On – Data logging; Blink – Communication (via RS-232);
Blink 2x – In operation

On – Insertion SD card

Moxa LAN Gateway:

Red: On – NPort booting up; Blink – IP conflict
Green: On – Power on; Blink – Location function

Orange: 10Mbps Ethernet connection; Green: 100Mbps Ethernet
sambungan
Orange: Receiving data; Green: Transmitting data

4G Modem:

LED on signal strength

LED on type of internet connection active
One LED blink device connected but no IP address

All LEDs blinking no SIM card or incorrect PIN

Terminasi

OK:

If you face any issues with terminations, contact our
specialists at +41 27 205 60 80 or visit
studer-innotec.com/support.

Ora OK:

Contact Studer Innotec SA at rue des Casernes 57, 1950 Sion,
Switzerland or email at info@studer-innotec.com.

Pitakonan sing Sering Ditakoni (FAQ)

P: Ing endi aku bisa nemokake manual pangguna online?

A: You can check the user manual online on our websitus.

Q: What should I do if I encounter an update error with the
xcom LAN/4G?

A: If you encounter an update error, refer to the
bagean ngatasi masalah ing manual pangguna utawa hubungi customer kita
dhukungan kanggo pitulungan.

“`

View Fullscreen

quick guide xcom LAN/4G
daya digawe swiss

Exclusion of liability Studer disclaims all responsibility and liability for damage, costs or losses resulting from an installation that does not comply with the instructions, a faulty operation or inadequate maintenance. The use of studer equipment is in any case under the responsibility of the customer. Read carefully the safety and operation instructions / Installation must be entrusted to qualified personnel / Check the user manual online / Need help ?
Exclusion de la responsabilité Studer décline toute responsabilité pour les dommages, les coûts ou les pertes résultant d’une installation non conforme aux prescriptions, d’un fonctionnement défectueux, ou d’un entretien déficient. L’utilisation des appareils studer relève dans tous les cas de la responsabilité du client. Lisez attentivement les instructions de sécurité et d’utilisation / L’installation doit être confiée à du personnel qualifié / Consultez le manuel d’utilisation en ligne / Besoin d’aide ?
Haftungsausschluss Studer übernimmt keinerlei Verantwortung und Haftung für Schäden, Kosten oder Verluste, die sich aus unsachgemäßer Installation, unsachgemäßem Betrieb sowie fehlerhafter Wartung ergeben oder in irgendeiner Art und Weise damit zusammenhängen. Der Einsatz und Betrieb der studer-Geräte obliegt in jedem Fall der Verantwortung des Kunden. Lesen Sie die Sicherheits- und Betriebsanweisungen sorgfältig durch / Die Installation muss qualifiziertem Personal anvertraut werden / Überprüfen Sie die Bedienungsanleitung online / Brauchen sie Hilfe ?
Exclusión de responsabilidad Studer declina cualquier responsabilidad por los daños, costes o pérdidas resultantes de una instalación no conforme con las recomendaciones, de un funcionamiento defectuoso o de un mantenimiento deficiente. El uso de equipos de studer es en cualquier caso responsabilidad del cliente. Lea atentamente las instrucciones de seguridad y funcionamiento / La instalación debe confiarse a personal cualificado / Consulte el manual de usuario en línea / ¿Necesitas ayuda?
1

Isi

xcom LAN

xcom LAN kit

kertu SD

xcom 4g

xcom 4G kit

kertu SD

Kabel Ethernet (a)

Kabel serial MF (b)

Antena (a)

Serial cable MM (b)

Kabel sumber daya (c)

Kabel komunikasi (d)

Kabel sumber daya (c)

Kabel komunikasi (d)

Wiring xcom LAN
a) Ethernet cable: Moxa Ethernet gateway <> Router b) Serial cable: Moxa Ethernet gateway <> xcom232i c) Power supply cable: Moxa Ethernet gateway <> xcom232i d) Communication cable: xcom232i <> xtender/vario All cables you need are provided in the set.
The metallic casing of the Ethernet gateway is connected to the negative battery pole. Therefore, it is necessary to isolate its casing from any metallic surface. Le boîtier métallique de la passerelle Ethernet est connecté au pôle négatif de la batterie. Il est donc nécessaire d’isoler son boîtier de toute surface métallique. Das Metallgehäuse des Ethernet-Passerele ist mit dem Minuspol der Batterie verbunden. Das Gehäuse muss von allen metallischen Oberflächen isoliert werden. La carcasa metálica de la pasarela Ethernet está conectada al polo negativo de la batería. Por lo tanto, es necesario aislar la carcasa de cualquier superficie metálica.
3

Wiring Xcom 4G Kab
a) Antenna b) Serial cable: TRB142 <> xcom232i c) Power supply cable: TRB142 <> xcom232i d) Communication cable: xcom232i <> xtender/vario
!xcom LAN/4G must be configured as xcom LAN! SIM card 1. Unscrew two back panel hex bolts and remove
the back panel. 2. Insert your SIM card into the SIM socket and
attach the panel and tighten the hex bolts.
Use an unlocked simcard / Utilisez une carte SIM débloquée Verwenden Sie eine entsperrte SIM-Karte / Utiliza una tarjeta SIM desbloqueada
(ora kalebu adaptor)
4

negara LED

xcom 232i

red green orange

on – update error or backup blink – updating process blink 2x – micro SD full
on – data logging blink – communication (via RS-232) blink 2x – In operation
on – Insertion SD card

Moxa LAN gateway

abang ijo

on – NPort booting up blink – IP conflict
on – power on blink – location function

orange 10Mbps Ethernet connection green 100Mbps Ethernet connection

orange receiving data green transmitting data

Modem 4G Kab

LED on signal strength

LED ing

type of internet connection active

one LED blink device connected but no IP address

All LEDs blinking no SIM card or incorrect PIN

Configuration xcom LAN/4G
1 SD card computer

2 xcom configurator

3 GUID

Can be downloaded from our websitus
!xcom LAN/4G kudu dikonfigurasi minangka xcom LAN!
4 SD card xcom 232i

5 rcc server connection

6 portal register installation

Terminations OK
Ora OK
Telpon spesialis +41 27 205 60 80 utawa bukak studer-innotec.com/support Studer Innotec SA rue des Casernes 57 1950 Sion, Swiss info@studer-innotec.com
© All rights reserved Studer Innotec SA V1.1

Dokumen / Sumber Daya

STUDER xcom LAN, 4G Communication Device [pdf] Pandhuan pangguna
xcom LAN 4G Communication Device, xcom LAN 4G, Communication Device, Device

Referensi

Manual pangguna

STUDER xcom LAN, 4G Communication Device User Guide

xcom LAN, 4G Communication Device

Informasi produk

Spesifikasi

Pandhuan Panggunaan Produk

Wiring xcom LAN

Wiring Xcom 4G Kab

Installation Steps for SIM Card