Nkà na ụzụ Hewei Eletrọnịkị HW58R12-WBDB Multi Protocol RFID Reader Module Akwụkwọ ntuziaka onye nwe

Product Specification Product

Foto ngwaahịa:

Atụmatụ na Ọrụ

• This module is a 13.56MHz RFID read/write module developed based on a multi-protocol readerchip；The reader chip supports ISO/IEC 14443 Type A/Type B protocols. Supports mobile payment applications such as Apple Pay and Samsung Pay. Supports P2P passive initiator mode under ISO/IEC 18092. Supports ISO/IEC 15693 protocol. Complies with EMV 3.0/3.1 certification, including electrical, protocol, and mobile compatibility tests. The module comes pre-integrated with operational commands for reading Mifare1 S50/S70, Mifare UltraLight, MifareDESFire, CPU cards, and second-generation Chinese resident ID cards.
• Wide ọrụ voltage range: 5V–24V；
  Supports RS232 serial communication with adjustable baud rate；
• Automatically detects card presence and outputs data via serial port；
• Supports Low Power Card Detection (LPCD)；
• LED Indicator Light Prompt.

Nkọwa nka nka

Conformal coating follows the following standards：

1. Spray coating thickness: 0.1-0.3 mm, with a cured thickness of 40-60 µm.
2. Conformal coating bubble standards: Bubbles are allowed on the plastic body or insulating parts of components, and small bubbles within the coating are acceptable. Only a single bubble enclosing a single part of a conductor is acceptable; bubbles between the component leads are not acceptable.
3. Exposed copper with tin plating, connectors, and power components should not be coated with conformal coating.
4. Components within 3 mm around the connectors do not require conformal coating, but a clear isolation strip of conformal coating must be present around the connectors.
5. No conformal coating is allowed within a 5 mm diameter of positioning holes, and holes should not be filled.
6. All IC component leads must be coated with conformal coating, and there should be visible traces of conformal coating on the body.

Salt Spray Testing is conducted in accordance with the following standards：

Nkwupụta FCC

1. ngwaọrụ a nwere ike ọ gaghị ebute nnyonye anya na-emerụ ahụ.
2. Ngwaọrụ a ga-anabatarịrị nnyonye anya ọ bụla enwetara, gụnyere nnyonye anya nwere ike ibute ọrụ na-achọghị.

Mara: A nwalere ngwa a wee hụ na ọ dabara na oke maka ngwaọrụ dijitalụ Klas B, dịka akụkụ 15 nke Iwu FCC. Emebere oke ndị a iji nye nchebe ezi uche dị na ya megide nnyonye anya na-emerụ emerụ na ntinye ụlọ. Akụrụngwa a na-ewepụta ojiji ma nwee ike ịgbasa ike ugboro redio yana, ọ bụrụ na etinyeghị ya ma jiri ya dịka ntuziaka ahụ siri dị, nwere ike ibute ndabichi na-emerụ ahụ na nkwukọrịta redio. Agbanyeghị, enweghị nkwa na nnyonye anya agaghị eme n'otu nrụnye. Ọ bụrụ na akụrụngwa a na-ebute nnyonye anya na-emerụ ahụ na nnabata redio ma ọ bụ telivishọn, nke enwere ike ikpebi site na ịgbanyụ ma gbanye akụrụngwa, a na-agba onye ọrụ ume ka ọ nwaa idozi nnyonye anya site na otu ma ọ bụ karịa n'ime usoro ndị a:

• Megharịa ma ọ bụ bugharịa antenna nnata.
• Mee ka nkewa dị n'etiti akụrụngwa na nnata.
• Jikọọ akụrụngwa n'ime oghere na sekit dị iche na nke ejikọrọ onye nnata.
• Kpọtụrụ onye na-ere ahịa ma ọ bụ onye ọrụ redio/TV nwere ahụmahụ maka enyemaka.
  Mgbanwe ma ọ bụ mgbanwe ndị otu na-ahụ maka nnabata na-akwadoghị nke ọma nwere ike imebi ikike onye ọrụ iji rụọ ngwa ahụ.

Nkwupụta Mkpughe Radiation FCC

Ngwaọrụ a na-akwado oke mkpughe radieshon FCC RF nke edobere maka gburugburu anaghị achịkwa. Agaghị ejikọta ihe nnyefe a ma ọ bụ na-arụ ọrụ na njikọ antenna ma ọ bụ nnyefe ọ bụla ọzọ.
Ngwaọrụ a ga -arụrịrịrịrị opekata mpe 20 cm n'etiti radiator na ahụ onye ọrụ

Akwụkwọ / akụrụngwa

Teknụzụ Eletrọnịkị Hewei HW58R12-WBDB Multi Protocol RFID Module Reader [pdf] Akwụkwọ ntuziaka onye nwe HW58R12-WBDB, HW58R12-WBDB Multi Protocol RFID Reader Module, Multi Protocol RFID Reader Module, RFID Reader Module, Reader Module, Module

Ntụaka

• Akwụkwọ ntuziaka onye ọrụ