ATA (Automatic Technology Australia) is a leading manufacturer of smart garage door openers, gate automation systems, and wireless access control solutions.
ATA (Automatic Technology Australia) is a world-class designer and manufacturer of smart access control systems for garage doors and gates. Known for their robust engineering and innovative security features, ATA products ensure safe and convenient access for homeowners and businesses alike.
Core product lines include the EasyRoller roll-up door openers, SecuraLift overhead openers, and the KPX and PTX series of wireless keypads and remote controls. ATA's proprietary TrioCode and SecuraCode technologies provide superior protection against code-grabbing and signal interference.
Note: This page may also list manuals for ATA-branded consumer electronics or fitness equipment, which are separate entities.
Latest manuals from manuals+ curated for this brand.
Common questions about manuals, registration, and support for this brand.
To program an ATA PTX-4 remote, press and hold the blue Door Code button on the garage opener motor (or SW1/SW2 on the receiver). While holding, press the button on the new remote you wish to use for two seconds, release for two seconds, then press the same remote button again. Release the Door Code button to finish.
For most ATA remotes like the PTX-4, remove the screws or casing cover to access the battery compartment. Replace the battery (typically a 12V A23 or CR2032, depending on the model) ensuring the positive and negative ends match the markings.
To delete all stored remotes: Turn off power to the motor. Press and hold the Door Code (or SW1) button. Turn the power back on while continuing to hold the button. The LED should illuminate or flash after a few seconds to indicate the memory has been cleared. Release the button and test to confirm.