N-98CVR Concealed Vertical ROD Exit Device
Instruction Manual
N-98CVR Concealed Vertical ROD Exit Device
TO CHANGE BOTTOM LATCH FOR BOTTOM STRIKE
- Device factory pre-set.
- -1.Unscrew and remove screw and L-shaped bracket. 2-2. The L-shaped bracket moves backward.
- Move the L-shaped bracket back to the (A) screw hole and install and lock it.
- Change Done.
INSTALL INNER CHASSIS & TOP LATCH
INSTALL BOTTOM LATCH (Skip this step if less Bottom Rod)
Attached Rod to Bottom latch
INSTALL TOP & BOTTOMSTRIKE (Please Follow TEMPLATE)
TO CHANGE HAND OF N-98CVR EXIT DEVICE
1. LHR |
2-1. Remove chassis pin & main slide & tube. 2-2. Remove lift lever & lift lever pin. 2-3. Rotate 180° main slide & lift lever  |
| 3-1. Reassemble lift lever at opposite side, as shown. 3-2. Replace main slide and chassis pin and lift lever pin. and fixed screw.  |
1. RHR Done. |
Documents / Resources
 |
CAL-ROYAL N-98CVR Concealed Vertical ROD Exit Device [pdf] Instruction Manual N-98CVR, N-F98CVR, N-98CVR Concealed Vertical ROD Exit Device, N-98CVR Vertical ROD Exit Device, Concealed Vertical ROD Exit Device, Vertical ROD Exit Device, Vertical ROD, Exit Device |
