WYBOT C1 Cordless Robotic Pool Cleaner Instruction Manual

1. Introduction

This manual provides essential information for the safe and efficient operation and maintenance of your WYBOT C1 Cordless Robotic Pool Cleaner. Please read this manual thoroughly before using the product and retain it for future reference.

Figure 1: WYBOT C1 Cordless Robotic Pool Cleaner

The WYBOT C1 is designed to provide comprehensive cleaning for in-ground pools up to 65 feet. It features ultra-strong suction, intelligent route planning, and the ability to clean floors, walls, and waterlines. Its cordless design offers convenience and ease of use.

2. Setup

2.1 Unpacking and Initial Inspection

Carefully remove all components from the packaging. Inspect the cleaner for any signs of damage. Ensure all parts listed in the packing list are present. If any items are missing or damaged, contact customer support immediately.

2.2 Charging the Cleaner

Before first use, fully charge the robotic pool cleaner. The powerful 8800mAh rechargeable battery provides up to 110 minutes of continuous run time. Full charging typically takes approximately 6.5 hours.

• Locate the charging port on the cleaner.
• Connect the charger to the cleaner and then to a power outlet.
• The indicator lights on the cleaner will show the charging status.
• Once fully charged, disconnect the charger and ensure the charging port cover is securely closed to maintain waterproofing.

3. Operating Instructions

3.1 Placing the Cleaner in the Pool

Ensure the cleaner is fully charged and the charging port is sealed. Simply drop the cleaner into the pool. It will sink to the bottom. The integrated smart buoy will float on the surface, allowing for easy retrieval.

Video 1: Demonstrates the WYBOT C1 being placed into a pool and beginning its cleaning cycle. The video highlights its cordless operation and intelligent navigation.

3.2 Cleaning Modes and Path Planning

The WYBOT C1 features intelligent path planning with advanced sensors and gyroscopes. It offers two types of path planning: an A-star path for optimal coverage and a regular wall-climbing path. This ensures methodical coverage with fewer missed spots, effectively cleaning floors, walls, and waterlines.

• The cleaner will automatically begin its cleaning cycle once submerged and activated.
• It is equipped with obstacle identification to avoid running into pool toys or other items on the pool floor.
• The triple-motor and powerful suction efficiently pick up debris such as sand, dirt, leaves, twigs, and dust.

3.3 Retrieving the Cleaner

Once the cleaning cycle is complete or the battery is low, the cleaner will typically park itself near a wall for easy retrieval. Use the smart buoy to pull the cleaner to the edge of the pool. Allow excess water to drain before lifting it out.

4. Maintenance

4.1 Cleaning the Filter

Regular cleaning of the filter is crucial for optimal performance. The cleaner features a reusable ultra-fine dual filter system and a 6-liter dust box designed to handle deep cleaning and capture various debris.

• Lift the top cover of the cleaner.
• Remove the filter basket.
• Empty any collected debris from the dust box.
• Rinse the filter thoroughly with a hose until clean.
• Reassemble the filter and place it back into the cleaner, ensuring it is securely latched.

5. Troubleshooting

If you encounter any issues with your WYBOT C1, please refer to the following common solutions:

• Cleaner not moving: Ensure the battery is fully charged. Check for any obstructions in the wheels or suction ports.
• Poor suction: Clean the filter basket and ensure it is free of debris. Verify that the suction ports are not blocked.
• Cleaner not climbing walls: Ensure the pool surface is clean and free of excessive algae. Check that the brushes are not worn.
• Charging issues: Verify the charger is properly connected and the power outlet is functional.

For persistent problems or issues not listed here, please contact WYBOT customer support.

6. Specifications

7. Warranty and Support

WYBOT provides a 2-year warranty for this product, along with a 30-day return period. For warranty claims, technical assistance, or any questions regarding your robotic pool cleaner, please contact WYBOT customer service through their official channels or the retailer where the product was purchased.