Casio LA20WH Series Digital Watch Instruction Manual

Introduction

This manual provides comprehensive instructions for the operation, maintenance, and troubleshooting of your Casio LA20WH Series Digital Watch. Please read this manual carefully to ensure proper use and to maximize the lifespan of your timepiece.

Key Features

• Ladies square digital watch
• 1/100 second stopwatch
• Alarm
• LED light for illumination
• Auto calendar
• Water-resistant design

Product Overview

Figure 1: Front view of the Casio LA20WH Series Digital Watch (Pink/White variant).

Figure 2: The Casio LA20WH Series Digital Watch as worn on a wrist, highlighting its compact and comfortable fit.

Setup

Setting Time and Date

1. In the Timekeeping Mode, press the MODE button until the seconds start to flash. This indicates you are in the setting mode.
2. Press the LIGHT button to cycle through the settings: Seconds → Hour → Minutes → Year → Month → Day.
3. Use the START/STOP button to adjust the flashing value. For seconds, pressing START/STOP resets them to 00.
4. To switch between 12-hour and 24-hour format, press the ALARM/CHRONO button while the hour or minute setting is flashing.
5. Once all settings are correct, press the MODE button to exit the setting mode.

Operating Instructions

Using the Stopwatch

1. From Timekeeping Mode, press the MODE button twice to enter Stopwatch Mode. The display will show "00'00"00".
2. Press START/STOP to start the stopwatch.
3. Press START/STOP again to stop it.
4. Press LIGHT to reset the stopwatch to "00'00"00".

Setting the Alarm

1. From Timekeeping Mode, press the MODE button three times to enter Alarm Mode. The alarm time will be displayed.
2. Press START/STOP to turn the alarm ON or OFF.
3. To set the alarm time, press the LIGHT button. The hour digits will flash.
4. Use the START/STOP button to adjust the hour.
5. Press LIGHT again to select the minute digits, then use START/STOP to adjust.
6. Press MODE to exit Alarm Mode.

Using the LED Light

To illuminate the display in low-light conditions, press the LIGHT button located on the upper right side of the watch. The light will stay on for a few seconds.

Care and Maintenance

Water Resistance

Your Casio LA20WH watch is water-resistant. This means it is suitable for everyday use and can withstand splashes or brief immersion in water. However, it is not suitable for swimming, diving, or prolonged water exposure. Avoid operating buttons while the watch is wet.

Cleaning

Wipe the watch with a soft, dry cloth to remove dirt and moisture. For stubborn stains, use a slightly damp cloth with mild soap, then wipe dry. Avoid using harsh chemicals or abrasive cleaners.

Battery Replacement

The watch uses 1 CR2 battery. When the display becomes dim or functions become erratic, it may be time to replace the battery. It is recommended to have battery replacement performed by a qualified watch technician to ensure water resistance is maintained.

Troubleshooting

• Display is blank or dim: The battery may be low or depleted. Replace the battery.
• Time is incorrect: Re-set the time and date following the "Setting Time and Date" instructions. Ensure the correct 12-hour or 24-hour format is selected.
• Buttons are unresponsive: Ensure the watch is not wet. If the issue persists, a reset may be required (refer to full manual if available) or contact customer support.
• Alarm does not sound: Check if the alarm is set to ON in the Alarm Mode. Ensure the volume is not muted if applicable (this model does not have volume control, but general advice).

Product Specifications

Warranty and Customer Support

For warranty information, service, or additional support, please refer to the warranty card included with your product or visit the official Casio website. You can also find more information and contact details on the Casio Store on Amazon.