AIPHONE IXGW-LC-RY20 IP Multi Tenant System
Specifications
- Product: IXGW-LC-RY20
- Type: Relay Adaptor
- Compatibility: IXG Series IP multi-tenant system with IXG-DM7-HID entrance station
- Function: Provides Form C dry contact closure for door release
FAQ
Q: Can the IXGW-LC-RY20 be paired with a standard IX Series door station?
A: No, the relay adaptor is specifically designed for use with an IXG Series IP multi-tenant system and IXG-DM7-HID entrance station.
Q: How can I get more information or assistance?
A: For further details or support, please contact Technical Support at Aiphone Corporation via their website www.aiphone.com or call 800-692-0200.
The IXGW-LC-RY20 is a relay adaptor for the IXG Series IP multi-tenant system. This adaptor provides a Form C dry contact closure used for door release when paired with an IXG-DM7-HID entrance station. The programmed relay output will activate when door release is activated on the paired IXG-DM7-HID entrance station. This relay will not pair with a standard IX Series door station.This document covers programming the IXGW-LC-RY20.
Registering and assigning outputs for the IXGW-LC-RY20
Open the IXG Support Tool, and open and existing system. Under View(V) change to Advanced.
- Select Advanced View
Click View(V) and click Advanced .
- Register Lift Control
Open Lift Control Settings and, click Registration .
Click the Enable check box for each IXGW-LC-RY20 that will be used. Station Name can be changed at this time.
- Assigning Relay Output
Click Pick Up Floor.
In the Filter section, select the Building Number / Building Name from the drop down. Then select the Adaptor Number / Name from the drop down. Click
.
The relay section will appear. Click the desired Relay Output Terminal check box for each IXG-DM7-HID station.
- Assign IP Address
Open Network Setttings and, click IP Address .
Enter the IP Address and Subnet Mask. Then click
.
- Associate Station
Open Connection and click Association Settings.
Select the Lift Control Adaptor from the Station Settings List and select the Lift Control Adaptor from the Station List. Then click .
Repeat for remaining stations.
Note:
After Associating, the stations will reboot This could take between 3 and 5 minutes depending on the station. - Upload Settings
Open Connection and click Upload Settings.
Select all stations by clicking their respective check box in the Select column.
Click
.
The Status column will verify if the upload was successful.
For more details about the features and information above, please contact Technical Support. Aiphone Corporation | www.aiphone.com | 800-692-0200
Documents / Resources
 |
AIPHONE IXGW-LC-RY20 IP Multi Tenant System [pdf] User Guide IXGW-LC-RY20 IP Multi Tenant System, IXGW-LC-RY20, IP Multi Tenant System, Multi Tenant System, Tenant System |