Zaptec Go Charging Solution
Get to know Zaptec Go
Included in the box:
Remove Front Cover
Mount the charging station
Make sure it’s level and at an appropriate height.
Place the power cable
Choose between three entry options (top, back and bottom). Punch out the knockout tab to install from 1 or 2.
Each charging station must be protected by a max. 40A Type A 30mA RCD circuit breaker.
Secure cable
Prevent cable from being dislocated by using the cable clamp and screws (max torque 3 Nm). Use the sealing cones to make the installation water resistant.
Electrical connection
Connect all wires and firmly press down all levers as illustrated. Then turn on the circuit breaker to continue.
Configure charging station
Scan the QR code with camera and complete the installation in the Zaptec App.
It is possible to configure the charging station without using the app, please note there might be limited functionality doing so.
Switch is located above the connection terminal.
Confirm green light
Configuration is completed when the charging station status indicator changes to flashing green and then turns to white status indicator.
Mount the Front Cover
Secure and lock the front cover (max torque 1 Nm).
Documents / Resources
 |
ZAPTEC Zaptec Go Charging Solution [pdf] User Guide Zaptec Go Charging Solution, Zaptec Go, Charging Solution |
