VEX-logo

VEX ROBOTICS 280-7729 EXP Controller

VEX-ROBOTICS-280-7729-EXP-Controller-

FEATURESVEX-ROBOTICS-280-7729-EXP-Controller-1

  1. L3 Joystick
  2. E Buttons E
  3. Power Button
  4. R3 Joystick/Joystick R3
  5. F Buttons F
  6. Power/Link LED
  7. Charge LEDA..
  8. USS Charge Port/PortChargeur USB
  9. R Buttons/Boutons R
  10. L Buttons/Boutons L

To Charge Controller:

Pour charger la telllcommande:

  1. Tum off Controller
  2. Connect USBCableA-C(269-6961) to Controller and attach charging adapter
  3. Plug into a power outlet
  4. Charging will start automatically

Adapter Not lncluded
Charging Input USBPort (recommended2.4Aor greater,minimum0.5A)VEX-ROBOTICS-280-7729-EXP-Controller-2

Charge LED Status:/Etat de la LED Charge/ Etat:

VEX-ROBOTICS-280-7729-EXP-Controller-3

 

 

 

 

 

 

To tumon/offVEX-ROBOTICS-280-7729-EXP-Controller-4press the power Pour controller

FCC NOTES

This equipment has been tested and found to comply with the limits for a class B digital device This equipment generates, uses and interference will not occur in a particular installati~ If this equipment does cause harm~ul interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by f ne or more of the following measures

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit, different from that to which the receiver is connected.
  • shielded cables must be used ith this unit to ensure compliance with the class BFCC limits

Warning: Changes or modifications to this unit not Jxpressly approved by the party responsible for compliance could void the user’s authority to aper.he the equipment.

Documents / Resources

VEX ROBOTICS 280-7729 EXP Controller [pdf] Instruction Manual
RAD20, UKU-RAD20, UKURAD20, 280-7729 EXP Controller, 280-7729, EXP Controller

References

Leave a comment

Your email address will not be published. Required fields are marked *