UniFi SWX-ENVR Enterprise Network Video Recorder

SPECIFICATION

• Mechanical
  • Dimensions: 481.4 x 480 x 132 mm (19 x 18.9 x 5.2″)
  • Weight: 15.8 kg (34.8 lb)
  • Enclosure material: SGCC steel
  • Mount material: SGCC steel
• Hardware
  • Management interface Ethernet In-Band
  • Networking interface (1) 1/2.5/5/10 GbE RJ45 port (2) 1/10 GbE SFP+ ports
    Power method Swappable dual AC power adapter, 12V, 45A
  • Power supply AC/DC, internal, 550W
  • Supported voltage range 100–240V AC
  • Max. power consumption 410W
  • Max. power budget for Drives 310W
  • ESD/EMP protection Air: ± 12kV, contact: ± 8kV
  • Button Factory reset
  • Ambient operating temperature -5 to 40° C (23 to 104° F)
  • Ambient operating humidity 5 to 95% noncondensing
  • Certifications FCC, CE. IC
• LEDs
  • System
    • Power: blue/white
    • Flashing white: bootup in progress
    • Flashing blue: firmware upgrading
    • Steady white: factory defaults, awaiting adoption
    • Steady blue: device is adopted
  • Ethernet
    Green: link/activity
  • SFP+
    Green: link/activity
  • HDD
    White: disk detected
    Amber: disk error

FCC/IC – Required Statement:
https://dl.ui.com/compliance/FCC_IC_required_statement_2023-01-10.pdf

PRODUCT OVERVIEW

Installation Guide

Safety Notices

(if applicable)

1. Read, follow, and keep these instructions.
2. Heed all warnings.
3. Only use attachments/accessories specified by the manufacturer.
   • WARNING: Failure to provide proper ventilation may cause fire hazard.
   • Keep at least 20mm of clearance next to the ventilation holes for adequate air flow.
   • WARNING: To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
   • WARNING: Do not use this product in location that can be submerged by water.
   • WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
   • WARNING: Use only IEC/EN 60825-1:2014 Class I SFP Modules, and for safety ensure not to look directly into ber cable ends.
   • WARNING: To maintain safety and ensure fire safety, hard drive trays with or without hard drives, must be installed at all times.
   • WARNING: To reduce the risk of injury from electric shock, remove all power cords to completely disconnect power from the system.

Battery Warning

(if applicable)

1. Do not expose cells or batteries to heat or fire. Avoid storage in direct sunlight.
2. Purchase battery recommended by manufacturer. Risk of explosion if replaced with incorrect type.

Electrical Safety Information

(if applicable)

1. Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified may result in improper operation, damage to the equipment, or pose a fire hazard if the limitations are not followed.
2. There are no operator serviceable parts inside this equipment. Service should be provided only by a qualified service technician.
3. This equipment is provided with a detachable power cord which has an integral safety ground wire intended for connection to a grounded safety outlet.

• a. Do not substitute the power cord with one that is not the provided approved type. Never use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the grounding wire.
• b. The equipment requires the use of the ground wire as a part of the safety certification, modification or misuse can provide a shock hazard that can result in serious injury or death.
• c. Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment.
• d. Protective earthing is provided by Listed AC adapter. Building installation shall provide appropriate short-circuit backup protection.
• e. Protective bonding must be installed in accordance with local national wiring rules and regulations. Radiation Exposure Statement
  • This equipment should be installed and operated with a minimum distance 20 cm between the radiator and your body.
  • This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
• Operating Frequency (MHz):
• Max. RF Output Power:

Declaration of Conformity

Hereby, UBIQUITI, declares that this device, ENVR, is in compliance with the essential requirements and other relevant provisions of Directives 2014/53/EU, 2014/30/EU, 2014/35/EU. The device has software that cannot affect the conformity with the RED, even if the software is changed or replaced. The full text of the EU declaration of conformity and detailed compliance information is available at the following internet address: ui.com/compliance

Ubiquiti International Holding B.V.
Ekkersrijt 3102, Son, Netherlands

FAQs

Q: What is the maximum number of cameras that can be supported by ENVR?

A: ENVR can support up to 70 4K cameras, 140 2K cameras, or 210 HD cameras.

Q: What are the LED indicators on the ENVR?

A: The LED indicators show power status, bootup progress, firmware upgrading, adoption status, network link/activity, and disk status.

Q: How should I handle hard drive trays for safety?

A: Hard drive trays, with or without hard drives, must be installed at all times to ensure safety and fire prevention.

Documents / Resources

UniFi SWX-ENVR Enterprise Network Video Recorder [pdf] Owner's Manual SWX-ENVR, SWX-ENVR Enterprise Network Video Recorder, Enterprise Network Video Recorder, Network Video Recorder, Video Recorder

References

• User Manual