Telos Alliance xNode2 Broadcast Audio Interfaces
Quick Start Guide
Telos Alliance xNode2 IP Audio Interface
Unboxing and Setup
Upon opening the package, you will find the following components:
- xNode2 Unit
- Rack Mounting Brackets
- Power Cable
- Network Cables
- Other Accessories
Installation Steps
- Connect the xNode2 to a power source and network switch. Allow approximately 40 seconds for the device to boot up.
- Press the power button once to activate the device.
- Hold the button for 5 seconds to reset the network settings if necessary.
- Configure the network settings on the display screen:
- Network Port 1 (top): Enter IP address, subnet mask, and AoIP settings.
- Network Port 2 (bottom): Enter IP address, subnet mask, and AoIP settings.
- Access the xNode2 interface by entering the IP address into a web browser on a connected computer.
- Log in using your username and password.
Additional Resources
For further information and detailed documentation, visit: docs.telosalliance.com/xnode2
Specifications
| Component | Description |
|---|---|
| xNode2 Unit | IP Audio Interface Device |
| Network Ports | Two network ports for connection |
| Power Supply | Standard power cable included |
FAQ
- How do I reset the network settings?
- Hold the power button for 5 seconds to reset the network settings.
- Where can I find the IP address for the xNode2?
- The IP address is displayed on the device screen after setup.
- What should I do if I cannot access the web interface?
- Ensure the device is properly connected to the network and that the correct IP address is entered in the browser.
Documents / Resources
 |
Telos Alliance xNode2 Broadcast Audio Interfaces [pdf] User Guide xNode2, xNode2 Broadcast Audio Interfaces, Broadcast Audio Interfaces, Audio Interfaces |
