inno IMX708 Camera Module
Katerangan
Leuwihview
- CAM-IMX708AF Camera Module Feature with Sony IMX708 Sensor, Autofocus lens, IR-filter, Compatible with Raspberry Pi Camera Module 3 Standard Version.
- CAM-IMX708AF can be used to take full HD video as well as stills photographs and feature an HDR mode up to 3 megapixels. It carries IR cut filter. Its operation is fully supported by the libcamera library, including Camera Module 3’s rapid autofocus feature: this makes it easy for beginners to use, while offering plenty for advanced users. Camera Module 3 is compatible with all Raspberry Pi computers.
- CAM-IMX708AF Camera Module Third Generation: Back-illuminated and stacked CMOS 12-megapixel image sensor (IMX708) with HDR for up to 3-megapixel output
- High-quality Image Output: 4608 × 2592 pixels, carrying IR cut filter, along with built-in 2D DPC and QBC Re-mosaic function, offering high SNR
- Autofocus System: Phase detection autofocuses
- CSI-2 serial Data Output: 2-wire serial communication, supporting I2C fast mode and fast-mode plus
Fitur
- Back-illuminated, stacked CMOS 12-megapixel IMX708 image sensor
- High signal-to-noise ratio (SNR), built-in 2D dynamic defect pixel correction (DPC)
- Phase detection autofocus (PDAF) for rapid autofocus
- Widang diagonal tina view: 75 degrees, common video modes: 1080p50, 720p100, 480p120, output RAW10
- Supports Raspberry PI5, PI4, PI3
SPESIFIKASI
| Sénsor | Sony IMX708 |
| Resolusi | 11.9 megapiksel |
| Ukuran sénsor | diagonal sensor 7.4mm |
| Ukuran piksel | 1.4μm × 1.4μm |
| Common video modes | 1080p50, 720p100, 480p120 |
| Kaluaran | RAW10 |
| saringan IR | Sumuhun |
| Autofocus system | Pokus Otomatis Deteksi Fase |
| Diménsi | 32x32mm(12.4mm height for Wide variants) |
| Panjang kabel pita | 150 mm |
| Panyambung kabel |
|
Hardware
Ukuran kaméra 
Camera Module Pins Out
 |
||||
| Pin # | Ngaran | Katerangan | ||
| 1 | GND | taneuh | ||
| 2 | CAM_D0_N | MIPI Data Lane 0 Negative | ||
| 3 | CAM_D0_P | MIPI Data Lane 0 Positive | ||
| 4 | GND | taneuh | ||
| 5 | CAM_D1_N | MIPI Data Lane 1 Negative | ||
| 6 | CAM_D1_P | MIPI Data Lane 1 Positive | ||
| 7 | GND | taneuh | ||
| 8 | CAM_CK_N | MIPI Clock Lane Negative | ||
| 9 | CAM_CK_P | MIPI Clock Lane Positive | ||
| 10 | GND | taneuh | ||
| 11 | CAM_IO0 | Daya Aktipkeun | ||
| 12 | CAM_IO1 | Indikator LED | ||
| 13 | CAM_SCL | I2C SCL | ||
| 14 | CAM_SDA | I2C SDA | ||
| 15 | CAM_3V3 | Input Daya 3.3V |
Autofocus Lens Information
| rentang fokus | 10 cm–∞ |
| Panjang fokus | 4.74 mm |
| Diagonal f ield of view | 75 derajat |
| Horizontal f ield of view | 66 derajat |
| Vertical f ield of view | 41 derajat |
| Focal ratio (F-stop) | F1.8 |
| IR-Filter | Sumuhun |
Sambungan 
Parangkat lunak
Ngaropéa config.txt
- sudo nano /boot/config.txt
- For the latest version raspberry Pi OS, it should be
- sudo nano /boot/firmware/config.txt
Add the content below to the last line
- dtoverlay=imx708
- Ganti kana
- camera_auto_detect=1
- ka
- camera_auto_detect=0
Reboot and use below command to preview
libcamera-hello -t 0
Dokuméntasi
- Camera Description on Raspberry Pi
- Camera Software On Raspberry Pi
TAROS KAMI
- Rojongan: support@inno-maker.com
- Harga bulk: sales@inno-maker.com
- Wiki: wiki.inno-maker.com
- Github: https://github.com/INNO-MAKER
| titimangsa | Révisi | Ngarobih Detil |
| 2024/09/08 | V1.0 | Mimiti Dileupaskeun |
Patarosan anu sering ditaroskeun
Is the CAM-IMX708AF Camera Module compatible with all Raspberry Pi models?
Yes, the camera module is compatible with Raspberry Pi 5, Pi4, and Pi 3 models.
What autofocus system does the camera module use?
The camera module uses Phase Detection Autofocus (PDAF) for rapid focusing.
Dokumén / Sumberdaya
 |
inno IMX708 Camera Module [pdf] Manual pamaké CAM-IMX708AF, IMX708 Camera Module, IMX708, Camera Module, Module |