STUDER next3 Three-Phase Hybrid Inverter
Introduction
You are about to install and use a high-end equipment that will play a central role in the energy management of your battery-based system. The next3 is the first device of our new generation of smart battery inverter/charger with advanced functions. This next3 has been designed, manufactured, assembled and tested in our factory in Switzerland. It has a 6-year warranty and is eligible for an extension 6+6, under the studercare+ program (not yet available, check with your studer representative for further information).
General Information
Exclusion of liability
Studer disclaims all responsibility and liability for damage, costs or losses resulting from an installation that does not comply with the instructions, a faulty operation or inadequate maintenance. The use of studer equipment is in any case under the responsibility of the customer.
Options & accessories
Mounting and installation
Storage and content
Mounting place
Fixing and dimensions
Wiring
Communication and power up
Display
Configuring the next
Multi units
Technical data
Maintenance and recycling
Except for the periodic check of the connections (tightening, general condition), the next does not require any particular maintenance. To dispose of this product, please use the service for the collection of electrical waste and observe all obligations in force in the place of purchase.
STUDER
- Call our specialists +41 27 205 60 80
- or visit studer-innotec.com/support
- Studer Innotec SA
- rue des Casernes 57
- 1950 Sion, Switzerland
- info@studer-innotec.com
Documents / Resources
 |
STUDER next3 Three-Phase Hybrid Inverter [pdf] User Guide next3, Three-Phase Hybrid Inverter, Hybrid Inverter, Three-Phase Inverter, Inverter, next3 Inverter |
