ZKTECO SenseFace 2A Fingerprint Sensor Biometrics User Guide

Recommended Installation Environment:
- Window with dimensions between 6.5ft to 10ft
- Avoid glass refraction and direct sunlight exposure
- Avoid heat sources near the device

Product Usage Instructions

Device Installation

Stick the mounting template sticker to the wall and drill holes according to the template.

Fix the backplate on the wall using wall mounting screws.
Attach the device to the backplate with a security screw.

Power Connection
Connect the provided AC Adapter rated at DC 12V 1.5A to power the device.

Ethernet Connection
Connect the device to a computer software via an Ethernet cable. Ensure IP addresses are correctly set as per the provided information.

Door Sensor & Exit Button Connection
Connect the door sensor, exit button, and lock relay according to the provided instructions based on the type of lock used (Normally Opened or Normally Closed).

Download Center
Scan the QR Code to download additional user manuals and guides for detailed information.

Installation Environment

Please refer to the following installation recommendations.

Device Installation

Stick the mounting template sticker to the wall and drill holes according to the mounting template sticker.

Fix the backplate on the wall using wall mounting screws.
Attach the device to the backplate.

Attach the device to the backplate with a security screw.

Power Connection

Recommended AC Adapter

12V ± 10%, at least 1500mA.

To share the power with other devices, use an AC Adapter with higher current ratings.

Ethernet Connection

Connect the device and computer software via an Ethernet cable. As shown in the example below:

Enter [COMM.] > [Ethernet] > [IP Address], input the IP address, and press M/OK.
Note: In LAN, the IP address of the server (PC) and the device must be in the same network segment when connecting to the software.

Door Sensor & Exit Button Connection

Lock Relay Connection

The system supports a Normally Opened Lock and a Normally Closed Lock. The NO LOCK (normally unlocks when power-on) is connected with ‘NO’ and ‘COM’ terminals, and the NC LOCK (normally locks when power-on) is connected with ‘NC’ and ‘COM’ terminals. Take NC Lock as an example below:

The device is not sharing power with the lock
Device sharing power with the lock

Download Center

Scan the QR Code to download the User Manual, Installation Guide, and Quick Start Guide.

FAQ

What should I do if the device is not powering on?
Check the power connection and ensure that the AC Adapter is properly plugged in and providing the correct voltage.
How can I reset the IP address of the device?
Navigate to [COMM.] > [Ethernet] > [IP Address], input the new IP address, and press M/OK to save changes.

Documents / Resources

ZKTECO SenseFace 2A Fingerprint Sensor Biometrics [pdf] User Guide
SenseFace-2A, FR107, SenseFace 2A Fingerprint Sensor Biometrics, SenseFace 2A, Fingerprint Sensor Biometrics, Sensor Biometrics, Biometrics

References

User Manual

ZKTECO SenseFace 2A Fingerprint Sensor Biometrics

Product Specifications