Two Steps Stool with Handle
Installation Guide

ASSEMBLY INSTRUCTION

 INSTALL THE FIRST CROSS BAR

• Handrail holders must face outwards.
• Use two M7*13mm screws and hex wrench.

INSTALL THE OTHERS TWO CROSS BARS

1. Use four M7*13mm screws and hex wrench.
2. Tighten the three cross bars and keep them level.

INSTALL THE UPPER WOODEN PANEL

• The panel with logo“YEEZOO” is the upper panel, logo outwards.
• Four countersinks face upwards.
• Use four M6*49mm screws and hex wrench to fix the panel.

INSTALL THE FIRST WOODEN PANEL

• Use four M6*49mm screws and hex wrench to fix the panel.
• Check and tighten all screws.

CONNECT THE DETACHABLE HANDRAI

• The bar connection and grab bar are screw thread connected.
• Two grab bar connections are the same, no distinction required.

INSTALL HANDRAIL AND NONS-SLIP PADS

• Insert the handail into the handrail holders.
• Use two M7*13mm screws and hex wrench to fix from it’s bottom.
• Stick the four non-slip pads included under support brackets.

Documents / Resources

YEEZOO Two Steps Stool with Handle [pdf] Installation Guide Two Steps Stool with Handle, Steps Stool with Handle, Stool with Handle, Handle

References

• User Manual