Parts List
- 2 Grab Bar Connections
- 2 Support Brackets
- 1 Grab Bar
- 3 Cross Bars
- 2 Wooden Panels
- 4 Non-slip Pads
- Hardware: 8x M6*49mm screws, 8x M7*13mm screws
Assembly Steps
1. INSTALL THE FIRST CROSS BAR
Handrail holders must face outwards.
Use two M7*13mm screws and hex wrench to attach.
2. INSTALL THE OTHERS TWO CROSS BARS
Use four M7*13mm screws and hex wrench.
Tighten the three cross bars and keep them level.
3. INSTALL THE UPPER WOODEN PANEL
The panel with the logo "YEEZOO" is the upper panel, with the logo facing outwards.
Four countersinks face upwards.
Use four M6*49mm screws and hex wrench to fix the panel.
4. INSTALL THE FIRST WOODEN PANEL
Use four M6*49mm screws and hex wrench to fix the panel.
Check and tighten all screws.
5. CONNECT THE DETACHABLE HANDRAIL
The bar connection and grab bar are screw-thread connected.
Two grab bar connections are the same, no distinction required.
6. INSTALL HANDRAIL AND NON-SLIP PADS
Insert the handrail into the handrail holders.
Use two M7*13mm screws and hex wrench to fix from its bottom.
Stick the four non-slip pads included under support brackets.