XPG DDR4 RGB Memory Module Instruction Manual
The cover product image is for illustration purposes only. This manual is applicable to all XPG M.2 SSD products.
BEFORE INSTALLATION
- GATHER THE THINGS YOU’LL NEED
PC, Phillips screwdrivers, and XPG M.2 SSD
*Please use a standard Phillips screwdriver (3.5mm) for disassembling the case; and a smaller Phillips screwdriver for installing the M.2 solid state drive as it uses screws with a diameter of 1.85-1.98mm
- BACK UP YOUR DATA
Make sure to backup the important data on your PC to an external device, such as an external HDD, before starting installation.
- POWER OFF YOUR PC
After backing up your data, power off your PC to avoid data loss or damage to other components during installation.
- SWITCH OFF THE POWER SWITCH AND UNPLUG POWER CORD
This action is necessary to discharge residual power that can damage your PC and its components.
*The battery removal step applies only to laptops when it’s possible to remove the battery. To see how to remove the battery, refer to your user manual.
INSTALLATION
- REMOVE YOUR PC’S BACK PLATE
Use your standard Phillips screwdriver to remove the screws from the back plate.
*If you are unsure how to do this, refer to your user manual
- LOCATE THE M.2 PCIe SLOT AND CONFIRM THERE ARE SCREWS
Locate the M.2 PCIe slot, ensure the SSD will fit and confirm there are screws present.
*The location of slots may vary by PC. Please check your PC’s user manual for more information.
**Generally speaking, the screws that secure the SSD in place will be installed on the motherboard when the laptop is shipped from the factory.
- ALIGN THE M.2 SLOT AND INSERT THE SOLID STATE DRIVE
Use your small Phillips screwdriver to remove the screws on the motherboard. Align the notches in the SSD with the ridges in the PCIe slot, then insert at a an angle. Give it a final push to ensure it is securely in place.
*The slot has a foolproof design. Please insert the SSD in thedirection corresponding to the pins on the solid state drive and the slot. Do not insert it forcibly to avoid damage to the product.
- FASTEN THE SCREWS TO SECURE THE SSD
Use your small Phillips screwdriver to secure the SSD into place.
*Do not overtighten the screws
- SECURE THE BACK PLATE INTO PLACE
*Do not overtighten the screws as it may cause damage
- PLUG IN THE POWER CORD AND POWER ON THE PC TO COMPLETE INSTALLATION
CUSTOMER SERVICE AND TECHNICAL SUPPORT Contact Us:
https://www.xpg.com/en/support/xpg?tab=ContactUs
Documents / Resources
 |
XPG DDR4 RGB Memory Module [pdf] Instruction Manual DDR4 RGB Memory Module, DDR4, RGB Memory Module, Memory Module |