Permafrost series liquid cooling
user’s manual

 

Secure the fan together with the radiator onto the chassis

Please clean the surface of CPU before applying thermal grease evenly on the CPU

Remove the INTEL clips and install the AMD clips

Remove the film from the waterblock’s base and place it on the CPU

Hook the clip onto the motherboard’s cooler retention bracket

Connect the water block and fan connectors onto the relevant motherboard connectors, installation complete

Make sure you are using the correct side of the backplate for your motherboard and insert the screw into the correct holes based on the CPU socket you use

Install the backplate assembly onto the motherboard and slip on the screw standoffs *Mount LGA2011 and INTEL clips and tighten the nuts

Please clean the surface of CPU before applying thermal grease evenly on the CPU

Remove the film from the waterblock’s base and place it on the CPU

Secure the spring screws onto the screws with a screwdriver

Connect the water block and fan connectors onto the relevant motherboard connectors, installation complete

Please confirm the connector, the definition, and direction of your pin header when connecting cables

• Ensure ARGB controller/motherboard has same +5V pin definition as PF120/PF240/PF360

Instructions for ARGB controller

1. There are three buttons on this controller, “+ / – / M”
2. M button: Press M button to switch to lighting effect mode, speed of lighting mode, brightness mode, and demo mode Press “+” or “–“ to adjust desired levels
3. Press M button for 3 seconds to turn off, press M button again to turn on, and resume to the last lighting effect mode before turning off
4.  When powered on for the first time, the default lighting effect is “Rainbow”
5.  After turning off or sudden power loss, the controller will resume to the last set lighting effect mode and level after power on
6.  Press “–“ button for 3 seconds under any modes will reset to default effect (Rainbow)
7.  Lighting effect mode
   1) Rainbow (default)
   2) Breathing
   3) Flashing
   4) Layering (8 colors: white, indigo, violet, yellow, blue, red, green, orange)
   5) Flowing
   6) 256 colors auto-switching (8 colors: white, indigo, violet, yellow, blue, red, green, orange) Press “+” for 3 seconds to lock the chosen color; press “–“ for 3 seconds to unlock color.
   7) Radar
   8) Color layering, red
   9) Color layering, green
   10) Color layering, blue
8. Press M button to switch mode Press “+” or “–“ when the controller’s red indicator lights up to adjust the speed of lighting (fast/slow)
9.  Press M button to switch mode Press “+” or “–“ when the controller’s blue indicator lights up to adjust brightness
10.  Press M button to switch mode Under demo mode, the controller’s yellow indicator lights up and will display and recycle all 10 lighting effects continuously

Documents / Resources

SILVERSTONE PF120 ARGB CPU Cooler [pdf] User Manual PF120, ARGB CPU Cooler

References

• User Manual