Robot Setup
- Set up Self-Empty Base
- Remove any plastic wrap and foam from the robot and base.
- Place the base in a location with a strong Wi-Fi signal.
- Dock LED will turn green when powered ON
Note: Check between the bumper and wheels to ensure all protective materials are removed before robot use. Place dock on clean, bare floor.
- Attach Side Brush
- Note: Side brush design may vary.
- Place Robot on Self-Empty Base
- Robot will turn on when properly placed on the dock.
- Dock LED will turn blue when the robot is charging
- Scan QR code to download theSharkClean® app to complete the robot setup.
What’s Included
Two Easy Steps If You’re Stuck
- Visit the app or sharkclean.com/support:
- Owner’s Guide
- Troubleshooting
- How-To Videos
- FAQs
- Tips & Tricks
- For additional help, please scan the QR code to visit the digital Owner’s Guide or call 1-888-228-5531 for robot support
Maximize Your Robot Experience:
Tips and tricks for getting the most out of your robot.
- To manually turn ON/OFF your robot, hold down the DOCK button for 5-7 seconds.
- Clear the area of cords and wires before each clean.
- Always place your robot on a level surface when performing maintenance.
- Clean brushroll, charging contacts, and filter regularly.
2023 SharkNinja Operating LLC. SHARK and SHARKCLEAN are registered trademarks of SharkNinja Operating LLC. SHARK MATRIX is a trademark of SharkNinja Operating LLC. APPLE and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. APP STORE is a service mark of Apple Inc., registered in the U.S. and other countries. GOOGLE, GOOGLE ASSISTANT, GOOGLE PLAY, the Google Play logo, and Android are trademarks of GOOGLE LLC.
Documents / Resources
 |
Shark UR2360S Matrix Plus Robot [pdf] User Guide UR2360S Matrix Plus Robot, UR2360S, Matrix Plus Robot, Plus Robot, Robot |
