SAVANT ESS-APPC3V15C40 Power Director System
Box Contents
- (1) Director (ESS-APPC3V15C40)
(2) SmartEnergy Voltage Sensor (SEM-VT01) - (2) 2.4-5 Ghz Antenna (045-0137-xx)
- (1) USB WiFi Adapter (069-0052)
- (1) 5V 3A DC 15w Power Supply (025-0233-xx)
- (2) Side Mount Chassis Bracket (071-0628)
- (1) 6 Pin Screw Down Plug-in Connector (028-0664-xx)
- (15) 2 Pin Screw Down Plug-in Connectors (028-0884-xx)
- (1) Product Regulatory Statement (009-1950-xx)
Accessories (Sold Separately)
SmartEnergy Voltage Sensor (SEM-VT01-xx)
Split Core Current Transformers (Clamp on) with 8ft Leads (SEM-xxxAx)
Front Panel
Right Panel
- A Reset Press and hold for 5 seconds to reset to factory defaults.
- B Test Press and release to enter Access Mode.
- C Pair Press and hold the Pair button for two seconds to enter Associate Mode.
- D GPIO GPIO Port to control devices.
- E Ethernet 8-pin RJ-45 port 10/100/1000 Base-T auto-negotiating port.
- F RS232 RS232 Control Port
- G Power Supply 120V AC to 5V 3A DC external power supply
- H Power LED Green: System has power and is operating normally.
Off: System is not receiving power. - I Status LED
Off: Disconnected from power supply. Amber: Host is booting/rebooting and is disconnected from the network.
Green: Connected to the local network and is assigned an IP Address. - J VT Connections (3) Voltage sensor input ports. Input for SEM-VT01 voltage sensor.
- K CT Connections (15) Input ports for each Current Transformer installed in the system.
- L Wifi + BLE Adapter Provides BLE connection to Companion Modules.
Documents / Resources
 |
SAVANT ESS-APPC3V15C40 Power Director System [pdf] User Guide ESS-APPC3V15C40, Power Director System, ESS-APPC3V15C40 Power Director System |
