TMR-190 Lithium Battery and MPP Inverter
Installation and configuration manual With for
Pytes Lithium Battery V Series & MPP Inverter
BOM List
Before installation, you should prepare following items as shown in Graph 1.
|
Item |
Remarks |
Quantity |
|
Power Cable (DC) |
☐ Conductor cross-section: UL10269-1/0AWG-200mm Amphonel 8.0mm Or TMR-190*25*18mm Cable diameters: 14 mm to 25 mm Only copper cables may be used. The DC cables must be sized for the maximum battery voltage and the maximum battery current. |
Depends on the number of batteries and the connection method |
|
RJ45 Cable |
RS485 communication Terminal (RJ45 port) follow RS485 protocol, to output batteries information. |
1 |
|
PC (Personal Computer) |
Self-Provide. |
1 |
|
Battery |
V series |
Depends on the number of batteries and the connection method |
|
Inverter |
MPP Inverter |
1 |
Graph 1.
How to Install
CAUTION: If you want to get more inverter-related settings, please refer to the inverter user manual first.
1.Communication Cable
Definition RS485 Port Pin for BMS is as follow.
RS485 port definition
|
Version |
Pin number of com. cable |
|
V version |
|
Pic 2
2.Power Cable Connection
Step.1
Before connecting all wirings, please take off bottom cover by removing two screws as shown Pic 4.1.
Step.2
Connect the red and black cables to the inverter DC connector as shown in Pic 4.2.
BATTERY+BATTERY-Pic 4.2
Step.3
At the other end of the cable, connect to the battery as shown Pic 4.3.
（Ensure that the battery power switch is off）
Pic 4.3
3. Communication Cable Connection
Step.1: Wire Set Up
a): Prepare one cable, one clamp and one scissor as shown in Pic 5.1.1.
Pic 5.1.1
b): Cut the cable skin at both ends to expose the wires as shown in Pic 5.1.2.
Pic 5.1.2
c): Arrange wires sequence according to pic2.(1-3,2-5)
d): Check the battery wire sequence.
e): Insert battery wire lines and inverter wire lines respectively into crystal heads.
f): Clamp two crystal heads tightly and take them out as shown in Pic 5.1.3.
Pic 5.1.3
Step.2: Cable Connection
Connect the inverter end of the cable to the inverter BMS port as shown in Pic 5.2.1. Make sure which communication port to use.
Pic 5.2.1
Connect the battery end of the cable to the battery communication port as shown in Pic 5.2.2 (Ensure the correct sequence of wires inside the communication cable).
Pic 5.2.2
4. Set the DIP Switch
Set the 1st dipswitch up and the rest of the switches down. Only the master battery requires the dip switches adjusted as shown in Pic 6.1
|
Version |
ADD setting |
|
V version |
|
Pic 6.1
5. Start Up the System
Start up the inverters and batteries.
6. Change the Battery Setting of The Inverter
※CAUTION: If you want more details about the batteries settings please check the operating manual of inverters.
Choose L16 in programme 3. (Some Mpp models will have this battery type setting in programme 5.)
Pic 8.1
END
Documents / Resources
 |
Pytes TMR-190 Lithium Battery and MPP Inverter [pdf] Instruction Manual TMR-190, 25, 18, TMR-190 Lithium Battery and MPP Inverter, TMR-190, Lithium Battery and MPP Inverter, MPP Inverter |
