Contents
hide
Lian Li SL-INF 240 GA II TRINITY Closed Loop ARGB AIO LIQUID CPU Cooler
Hardware List
Apply thermal paste
- Default Orientation
- Rotate Orientation
- The control film direction depends on the CPU, please follow the left reference to place the control film in a different tube orientation
Rotate the pump
- Peel the protective film
- Default Orientation
- Rotate Orientation
- In consideration of performance, only offer these 2 tubes’ outlet orientation
- Secure the AMD latch onto the platform’s retention clip and tighten it with a spring nut
Mount in the chassis
Customize pump cover
Remove the outer cover
Install the inner cover L & K
- Hold on top of the latch for easier positioning with force
- Place the latch in the slot and twist the inner cover to install properly
- Place the latch in the suitable slot and twist the outer cover to install properly
The cable connection of the pump
- Attention! The cable convex side on the interface shall face upward
Restriction of Controller
- Controller maximum outputs 22.5W.
- Control lighting effects with L-Connect 3: Please lower the brightness when set to static white.
- Sync lighting effects to the motherboard: Supports a maximum of 6 UNI FAN SL-INF fans when set at static white 100% brightness.
Fan removal
Steps to switch the orientation of the cable on the power module
Cable Connection Guide
- Warning! Do not connect the wrongtype of LED connector. If it is connected to the 12 V connector, permanent damage will occur
- Connection guide for extra UNI FAN SL-INF single-pack
Use of magnetic adhesive
G50.GA2T24-36IN.01
Documents / Resources
 |
Lian Li SL-INF 240 GA II TRINITY Closed Loop ARGB AIO LIQUID CPU Cooler [pdf] Installation Guide SL-INF 240 GA II TRINITY Closed Loop ARGB AIO LIQUID CPU Cooler, SL-INF 240 GA II, TRINITY Closed Loop ARGB AIO LIQUID CPU Cooler, Closed Loop ARGB AIO LIQUID CPU Cooler, Loop ARGB AIO LIQUID CPU Cooler, AIO LIQUID CPU Cooler, LIQUID CPU Cooler, CPU Cooler, Cooler |
