Quad T-Junction Connects LDSBus Devices Sensors
Product Information
The LDSBus Quad T-Junction is a device that connects LDSBus Devices (Sensors/Actuators) to the LDSBus. It allows for the connection of up to four LDSBus Devices, and additional Quad T-Junctions can be daisy-chained to add more devices to the LDS Bus.
Setup Instructions
- Connect the first LDSBus Quad T-Junction to any of the LDSBus Host Systems using an RJ45 (CAT5e) cable.
- Connect the configured LDSBus Device(s) to the LDSBus Quad T-Junction as shown in the picture.
- If there is more than one LDSBus Quad T-Junction in the system, chain them together as shown in the picture.
Note:
Enable termination for the last LDSBus Device in the bus.
Please scan QR code A or visit https://brtsys.com/warranty for warranty registration using the UUID and Product Key. Alternatively, you can scan QR code B.
Setup Instructions
The LDSBus Quad T-Junction connects LDSBus Devices (Sensors/Actuators) to the LDSBus. Each junction can connect up to four LDSBus Devices and additional LDSBus Quad T-Junctions may be daisy chained to add more LDSBus Devices to the LDS Bus.
- Step 1:
Connect the first LDSBus Quad T-Junction to any of the LDSBus Host Systems using an RJ45 (CAT5e) cable. - Step 2:
Connect the configured LDSBus Device(s) to the LDSBus Quad T-Junction as shown in the picture. - Step 3:
If there is more than one LDSBus Quad T-Junction in the system, chain them together as shown in the picture.
Note: Enable termination for last LDSBus Device in the bus
Warranty
Please scan QR code A or visit https://brtsys.com/warranty for warranty registration using the UUID and Pro duct Key.
View the full information on the LDSBus Quad T-Junction, application setup and installation at https://brtsys.com/resources/ or scan QR Code B.
Documents / Resources
 |
LDSBus Quad T-Junction Connects LDSBus Devices Sensors [pdf] User Guide Quad T-Junction, Quad T-Junction Connects LDSBus Devices Sensors, Connects LDSBus Devices Sensors, LDSBus Devices Sensors, Devices Sensors, Sensors |
