JANOME 202-464-008 Bias Tape Guide and Belt Loop Folder
JANOME BULLETIN
For CoverPro Models
Bias Tape Guide and Belt Loop Folder
This attachment can be used in two ways: as a “Bias Tape Guide” that can guide bias tape (single fold) and sew it on to knit fabric, and as a “Belt Loop Folder” that can make belt loops from fabric tape. This attachment is useful for creating various types of sewing work.
- Stitch pattern:Top cover stitchWide 6 mm Cover stitchWide 6 mm
- Co verPro 900CPX: Cover stitch Wide 5 mm
Bias Tape Guide
Attach the attachment to the 2 holes on the front right of the CoverPro Models with the attachment screws (standard accessories).
Belt Loop Folder
Attach the attachment to the 2 holes on the front left of the CoverPro Models with the attachment screws (standard accessories).
Instead of bias tape, can also use ribbons of around the same width. Enjoy creating decorative knit works!
- It is easier to use with the Extra Wide Table #795812008 (Optional Item)
- ⁷/16” (11 mm) wide belt loops can be easily made from 1” (25 mm) wide strips of fabric
- Medium-heavy fabrics (10 oz denim or chino cloth, etc.) are recommended
- After making a long belt loop, cut it to the appropriate length for each piece.
- Fold back the edge of the 1” (25mm) fabric tape to form a ¼” (6mm) fold and iron it.
Tips
How to adjust Bias Tape Guide on the CoverPro Models
If the seam line seems out of alignment, adjust the Bias Tape Guide position by loosening the attachment screws.
- JTM-1078 15 September 2021
Tips
- How to adjust Belt Loop Folder on the CoverPro Models
- If the seam line seems out of alignment, adjust the Belt Loop Folder position by loosening the attachment screws.
Documents / Resources
 |
JANOME 202-464-008 Bias Tape Guide and Belt Loop Folder [pdf] Instructions 202-464-008, Bias Tape Guide and Belt Loop Folder, 202-464-008 Bias Tape Guide and Belt Loop Folder, Belt Loop Folder, Loop Folder, Folder |
