TAKE THE FIELD
SIO520E24 Edge Support System Stub Out Bracket With Flat Tabs, 1/8 in Hole Steel Galvanized
Installation Guide
SIO520E24 Edge Support System Stub Out Bracket With Flat Tabs, 1/8 in Hole Steel Galvanized
| Position wide top lip over the back edge to hook onto bracket | Then align tooth with hole in bracket. Install the clamp from the flat side (face) of the bracket. | Use thumb and push wide lower lip onto bracket to engage the clamp. |
 |
 |
 |
| Install CTS pipe or stub out into pipe hole opening. | Push thumb tab down and slightly forward to engage both edges of the bracket. | Completed installation. |
 |
 |
 |
Face of Stud
Use screws or nails to secure bracket to either the front or inside of stud.
Inside Stud
Bend in both tabs to fit the bracket inside the stud bay.
Narrow Stud Bays
For narrow stud bays, break perforation at the corner of the bracket to best fit the opening.
CAUTION: Brackets have sharp edges.
Wear gloves and use caution when installing the product.
WARNING: Cancer and Reproductive Harm.
www.P65Warning.ca.gov
TAKE THE FIELD
Support
14940 Thunderbird Road
Kansas City, MO 64147
P: 1.800.821.3944
F: 1.800.758.5950
www.siouxchief.com
#IS-520-E
Documents / Resources
 |
Sioux Chief SIO520E24 Edge Support System Stub Out Bracket With Flat Tabs, 1/8 in Hole Steel Galvanized [pdf] Installation Guide SIO520E24 Edge Support System Stub Out Bracket With Flat Tabs 1 8 in Hole Steel Galvanized, SIO520E24, Edge Support System Stub Out Bracket With Flat Tabs 1 8 in Hole Steel Galvanized, Flat Tabs 1 8 in Hole Steel Galvanized, Hole Steel Galvanized |
