SILVERSAVER 1000 Metal Detecting Flatware Retriever Lid
This Quick Start Guide does not replace the User Manual.
The full-length User Manual is available to download at www.GetSilverSaver.com, and should be read thoroughly to ensure proper use and maximum savings.
Green numbers are references to pages in the full-length manual that contain further information relevant to the section.
Red numbers are references to pages in the full-length manual that contain
important safety information that must be read prior to proceeding.
Charging
Charge the control box prior to use.
Apply Ramekin Savers
If you plan to use Ramekin Savers to prevent the loss of your non‑metallic ramekins, attach them to the bottom of clean, dry ramekins.
Assembly
Operation
False Alarms
The SilverSaver 1000® has two detection modes — Full Detection Mode and Reduced Detection Mode (RDM).
If foil products are not commonly found in the waste stream, use Full Detection Mode.
If waste foil is causing frequent false alarms, use Reduced Detection Mode (RDM).
Common foil products include:
- Aluminum foil
- Some creamer tops
- Some butter wrappings
- Some bottle labels
Full Detection Mode (Default)
With the unit ON, hold down the Reset button
and then press the Volume Up Button 
.
A rising tone and Detection Mode Light (blue)
OFF indicates the unit is now in Full Detection Mode.
Reduced Detection Mode (RDM)
With the unit ON, hold down the Reset button and then press the Volume Down Button
. A falling tone and Detection Mode Light (blue) ON indicates the unit is now in Reduced Detection Mode.
Cleaning
Preparation For Tomorrow
It is recommended that the battery be charged every night, even though the Low Battery Light (green) may not be flashing.
Documents / Resources
 |
SILVERSAVER 1000 Metal Detecting Flatware Retriever Lid [pdf] User Guide 1000 Metal Detecting Flatware Retriever Lid, 1000, Metal Detecting Flatware Retriever Lid, Detecting Flatware Retriever Lid, Flatware Retriever Lid, Retriever Lid, Lid |
