SilverSaver – Smart Flatware Detector
User Guide for SILVERSAVER models including: 1000 Metal Detecting Flatware Retriever Lid, 1000, Metal Detecting Flatware Retriever Lid, Detecting Flatware Retriever Lid, Flatware Retriever Lid, Retriever Lid, Lid
File Info : application/pdf, 4 Pages, 6.53MB
DocumentDocumentSilverSaver® 1000 Quick Start Guide This Quick Start Guide does not replace the User Manual. The fulllength User Manual is available to download at www.GetSilverSaver.com, and should be read thoroughly to ensure proper use and maximum savings. Green numbers are references to pages in the fulllength manual that contain further information relevant to the section. Red numbers are references to pages in the fulllength manual that contain important safety information that must be read prior to proceeding. 1. Charging 14 15 Charge the control box prior to use. 2. Apply Ramekin Savers 11 If you plan to use Ramekin Savers to prevent the loss of your nonmetallic ramekins, attach them to the bottom of clean, dry ramekins. Contact 18777676522 | mail@GetSilverSaver.com | www.GetSilverSaver.com 3. Assembly 5 & 6 1 2a... ...2b 3 4 5 CLICK 490104113EN 4. Operation 8 1 2 Power On 4 3 5 CLICK False Alarms The SilverSaver 1000® has two detection modes -- Full Detection Mode and Reduced Detection Mode (RDM). If foil products are not commonly found in the waste stream, use Full Detection Mode. If waste foil is causing frequent false alarms, use Reduced Detection Mode (RDM). Common foil products include: · Aluminum foil · Some creamer tops · Some butter wrappings · Some bottle labels Full Detection Mode (Default) With the unit ON, hold down the Reset button and then press the Volume Up Button . A rising tone and Detection Mode Light (blue) OFF indicates the unit is now in Full Detection Mode. Reduced Detection Mode (RDM) With the unit ON, hold down the Reset button and then press the Volume Down Button . A falling tone and Detection Mode Light (blue) ON indicates the unit is now in Reduced Detection Mode. 5. Cleaning 12 & 13 6. Preparation For Tomorrow It is recommended that the battery be charged every night, even though the Low Battery Light (green) may not be flashing. 7. Troubleshooting 16 & 17