SIEMENS - logoInstallation Instructions
Models RR-35 and RRS
Remote Reset Module and Remote Reset Station
(for use with System 3)SIEMENS RR-35 Remote Reset Module and Remote Reset Station - Diagram

OPERATION

The Model RR-35 Remote Reset module from Siemens Industry, Inc. allows a System 3 alarm condition to be reset to Standby from a remote location. (An alarm condition  can also be reset by using the CP-35 Control Panel RESET switch.)
System 3 uses a BC-35 battery backup configuration.
Use the interconnecting cable, P/N 600-191771, that is supplied. (See Figure 2.)
The Model RRS Remote Reset station includes a labeled single gang plate and a normally closed, key operated, spring return reset switch.

INSTALLATION AND WIRING

Follow the Connection Diagram (Figure 1) and Figure 2 to install and wire the RR-35/RRS into a System 3 configuration.
Refer to System 3 Wiring Information Field Assembly of Modules, P/N 315-085178.SIEMENS RR-35 Remote Reset Module and Remote Reset Station - Diagram 2

Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
P/N 315-091469-7
Siemens Canada Limited
Building Technologies Division
2 Kenview Boulevard
Brampton, Ontario L6T 5E4 Canada

Documents / Resources

SIEMENS RR-35 Remote Reset Module and Remote Reset Station [pdf] Instruction Manual
RRS, RR-35, RR-35 Remote Reset Module and Remote Reset Station, Remote Reset Module and Remote Reset Station, Reset Module and Remote Reset Station, Remote Reset Station, Reset Station

References

Leave a comment

Your email address will not be published. Required fields are marked *