True Wireless Headset
Quick Gide Please read this guide carefully before use and keep it for future use
Turn On
Press the earphones for 5 seconds or Take out from the charging case, with the red light flashing and beep (power on)
Turn Off
Put the earphones back to the charging case or press the earphone for 5 seconds, with lights o RR and beep(power or )
Headphone Pairing
Automatically pairing when taking out from the charging case, with the main earphone flashing red light and the [Dilated earphone indicator light off, and beep(connected)
Headphone Connection
There is a beep connected when the earphones are successfully connected.
Smart Touch Control
Play/Pause Music: Tap either side of the earphones Previous Song: Tap the right earphone twice Next Song: Tap the left earphone twice
Voice Assistant:
Press the left/right earphone for 3 seconds to active Siri Answer the Call: Tap the left/right earphone to answer Hang Up the Call: Tap the left/right earphone to hang up
Distance
15 Meters
Headphone Charging
Low battery warning: When voltage is lower than 3.4V, the light off, and bee Shutdown voltage: Immediately shut down when the voltage is lower than 3. off and a beep (power off)
Charging Box Charging
Wireless charging, with the red light, flashing; the red light will always be on when fully charged. (Fast charging and fully charged about 1 hour)
Insert the USB to charge, with the red light flashing; the red light is always on when fully charged. 
Other functions
No connection or disconnection: automatically turn off when idle over 5 minutes, with the red light flashing and beep (power off)
iPhone Battery Display:
The iPhone has a battery display when connected.
iPhone Volume Synchronization:
The earphone’s volume is synchronized with the phone volume.
Automatically Reconnect
Auto-connect to the previous device when restart.
Long-distance Disconnect and Auto-reconnect:
Auto—disconnect over 8 meters, Auto-connect within
Incoming Call Voice Report:
Automatically report incoming numbers, with the red light flashing.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Headphone Mode: E-Buds
MADE IN CHINA
Documents / Resources
 |
Shenzhen Weixin Yiheng Technology EBUDSX True Wireless Headset [pdf] User Guide EBUDSAIR, 2A46B-EBUDSAIR, 2A46BEBUDSAIR, EBUDSX True Wireless Headset, True Wireless Headset, Wireless Headset, Headset |
