برين چائلڊ IA10 انڊيڪيٽر ۽ الارم يونٽ يوزر گائيڊ
IA10 اشارو ۽ الارم يونٽ
Model: IA10 Ver. QS0IA101A EN
1. ڪڏهنVIEW & APPEARANCE
2. ڊسپلي ۽ ڪيز
مينيو کي 5 گروپن ۾ ورهايو ويو آھي. اهي هن ريت آهن:
1) PV & SetPoint (PV1/ PV2)
2) Manual Mode Menu (MANU)
3) Setup Menu (SET)
4) Calibration Mode Menu (CALI)
نوٽ:
The flow chart shows a complete list of all parameters. For actual application, the number of available parameters will vary depending on the setup and will be less than that shown in the flow chart.
4. PARAMETERS DESCRIPTION
5. Communication Address Full Table v1.2
6. پروگرامنگ
سائن ان جي چڪاس
INPT: Select the sensor type or signal type for signal input
Range: (Thermocouple) J_tC, K_tC, T_tC, E_tC, B_tC, R_tC, S_tC, N_tC, L_tC, U_tC, P_tC, C_tC, d_tC(RTD) PT.DN, PT.JS, (Linear) 4-20, 0-20, 0-5V, 1-5V, 0-10V, 0-1V, 0-50mV
ٻيهر ٽرانسميشن
The signal conditioner will output (retransmit) PV on its output terminals of output1, output2 and output3. ANL1 and ANH1 are adjusted to specify the low scale and high scale values of output1 retransmission. Similarly, ANL2, ANL3, ANH2 and ANH3 parameters are adjusted for output2 and output3.
Zero and Span adjustment
The signal conditioner has the option to adjust the zero and span of the outputs to meet the required accuracy. The user can adjust the parameters otZ1, otZ2 and otZ3 to adjust the zero value of the output1, output2 and output3 respectively. The user can adjust the parameters otS1, otS2 and otS3 to adjust the span value of the output1, output2 and output3 respectively. The allowable range for zero and span adjustment is from -1.000 to 1.000.
7. غلطي ڪوڊ
8. وائرنگ ڊاگرام
ٽرمينل ڪنيڪشن
For assistance contact Tech Support: service@brainchild.com.tw; 886-2-2786-1299; http:// www.brainchildtw.com
**This specification is subject to possible change without prior notice.
Copyright © 2025, All Right Reserved
هن دستور بابت وڌيڪ پڙهو ۽ PDF ڊائون لوڊ ڪريو:
دستاويز / وسيلا
 |
Brainchild IA10 Indicator and Alarm Unit [pdf] استعمال ڪندڙ ھدايت QS0IA101A, EN, IA10 Indicator and Alarm Unit, IA10, Indicator and Alarm Unit, Alarm Unit, Unit |