Saginaw Control SCE-NEXD12-SS Series External Disconnect Installation Guide
Gasket Installation:
Starting at the bottom of the external disconnect, install the gasket (item 6) around the side of the enclosure between the edge and the holes. Edge the end of the gasket up to the start point to ensure no water can travel through.
Using the provided bolt pack (item 2) use the mounting hardware to mount the external disconnect.
Read More About This Manual & Download PDF:
Documents / Resources
 |
Saginaw Control SCE-NEXD12-SS Series External Disconnect [pdf] Installation Guide SCE-NEXD12-SS, SCE-NEXD12A6-SS, SCE-NEXD16-SS, SCE-NEXD18-SS, SCE-NEXD18A6-SS, SCE-NEXD24-SS, SCE-NEXD24A6-SS, SCE-NEXD12-SS Series External Disconnect, SCE-NEXD12-SS Series, External Disconnect, Disconnect |
