SAGE-LU-MEI-logo

SAGE LU MEI R1 10-Key RF Remote Controller

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-product

1,4,8 zone dimming/10-key/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix 

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-fig-1

Features

  • Apply to single color or dual color LED controller.
  • Each remote can match one or more receivers.
  • CR2032 battery powered.
  • Operate with LED indicator light.
  • Magnet on the back which can be easily stuck on back holder or any metal surfaces.

Technical Parameters

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-fig-2

Mechanical Structures and Installations

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-fig-3

To fix the remote, three options are offered for selection:

  • Option 1: stuck the remote on any metal surfaces directly.
  • Option 2: fix the remote’ back holder on the wall with two screws.
  • Option 3: adhere the remote’ back holder to the wall with a paster.

Match Remote Control

The end user can choose the suitable match/delete ways. Two options are offered for selection:

Use the controller’s Match key

  • Match:
    Short press the match key, and immediately press on/off key (single zone remote) or zone key (multiple zones remote) on the remote. The LED indicator fast flash a few times means the match is successful.
  • Delete:
    Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.

Use Power Restart

  • Match:
    Switch off the power, then switch on the power, and repeat again. An immediately short press on/off key (single zone remote) or zone key (multiple zones remote) 3 times on the remote. The light blinks 3 times means the match is successful.
  • Delete:
    Switch off the power, then switch on the power, and repeat again. An immediately short press on/off key (single zone remote) or zone key (multiple zones remote) 5 times on the remote. The light blinks 5 times means all matched remotes were deleted.

Key function

R1 1 zone dimming remote

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-fig-4

  • Brightness+/-:
    • Short press 10 levels,
    • long press 1-6s for continuous 256 levels adjustment.
  • Scene 1/2:
    • Brightness memory.
    • Short press recalls the scene,
    • long press 2s save the current brightness into the scene. the LED indicator will light up longer when save OK.

R2 1 zone CCT remote 

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-fig-5

  • Color temperature+/-:
    Short press 11 levels, long press 1-6s for continuous 256 levels adjustment.
  • Brightness+/-:
    Short press 10 levels, long press 1-6s for continuous 256 levels adjustment.
  • Scene 1/2:
    Short press recalls the scene, long press 2s save the current color into the scene. the LED indicator will light up longer when save OK.

RU4 4 zone dimming remote 

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-fig-6

  • All on: Turn on all 4 zone light.
  • All off: Turn off all 4 zone light.
  • Zone 1-4 on:
    Short press turn on zone light, long press 1-6s increase brightness continuously.
  • Zone 1-4 off:
    Short press turn off zone light, long press 1-6s decrease brightness continuously.

RU8 8 zone dimming remote 

SAGE-LU-MEI-R1-10-Key-RF-Remote-Controller-fig-7

  • All on: Turn on all 8 zone light.
  • All off: Turn off all 8 zone light.
  • Zone 1-8 on/off:
    Short press turn on/off zone light, long press 1-6s increase or decrease brightness continuously.

Safety information

  1. Read all instructions carefully before you begin this installation.
  2. When installing battery, pay attention to the battery positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
  3. If no response from the receiver, please re-match the remote.
  4. Gently handle remote, beware of falling.
  5. For indoor and dry location use only.

Documents / Resources

SAGE LU MEI R1 10-Key RF Remote Controller [pdf] User Manual
R1, R2, 10-Key RF Remote Controller, RF Remote Controller, Remote Controller, R1, Controller

References

Leave a comment

Your email address will not be published. Required fields are marked *