SKYDANCE RM1 6 Key RF Remote Controller
Remote Controller
1 zone dimming/6-key/Wireless remote 30m distance/CR2032 battery
Features
- Apply to single color or dual color LED controller.
- Each remote can match one or more receiver.
- CR2032 battery powered.
- Operate with LED indicator light
Technical Parameters
Input and Output | |
Output signal | RF(2.4GHz) |
Working voltage | 3VDC(CR2032) |
Working current | <5mA |
Standby current | <2μA |
Standby time | 2 years |
Remote distance | 30m(Barrier-free space) |
Safety and EMC | |
EMC standard (EMC) | ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4 |
Safety standard(LVD) | EN 62368-1:2020+A11:2020 |
Radio Equipment(RED) | ETSI EN 300 328 V2.2.2 |
Certification | CE,EMC,LVD,RED |
Mechanical Structures and Installations
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match:
Short press match key, immediately press on/off key on the remote. The LED indicator fast flash a few times means match is successful.
Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted
Use Power Restart
Match:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key 3 times on the remote. The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key 5 times on the remote. The light blinks 5 times means all matched remotes were deleted.
Key function
RM1 1 zone dimming remote
- On/Off
- Turn off light ater 3Os, long press 2s will turn ott light after 60s.
- 50% brightness
- 10% brightness tor small night light
- Brightness+
- Brightness-
RM2 1 zone CCT remote
- On/Off
- Turn off light after 30s, long press 2s will turn off light after 60s.
- Color temperature +
- Color temperature
- BrightnesS+
- Brightness
Color temperature+/-:
Short press 11 levels, long press 1-6s for continuous 256 levels adjustment.
Brightness+/-:
Short press 10 levels, long press 1-6s for continuous 256 levels adjustment.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing battery, pay attention to the battery positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle remote, beware of falling.
- For indoor and dry location use only.
Documents / Resources
![]() |
SKYDANCE RM1 6 Key RF Remote Controller [pdf] User Manual RM1, 6 Key RF Remote Controller, RM1 6 Key RF Remote Controller, RF Remote Controller, Remote Controller, Controller |