ROLL A SHADE RASCP4CMVER.1 Assembled Cassette with Shade
Product Information
Specifications
- Model: RAS – Contract Plus+ Shade 4 Cassette Motorized UL
- Address: 12101 Madera Way Riverside, CA 92503
- Phone: 888-245-5077
- Fax: 951-245-5075
- Website: www.rollashade.com.
Hardware Included
Tools Required
INSTALLATION
- Install Cassette Holders
Install one cassette holders at each end and the rest spaced evenly across the shade. The edge holder should be as close to the edge as possible and no more than 6” from the edge. Then, install double bearing pin end bracket. Make sure ALL holders are level.
Note: If screws do not secure into stud, use supplied drywall anchors. < 90” = 3 holders
Note: Must be at least two screws in every bracket > 90” = 4 holders
- Install Cassette
Take assembled cassette and line up the top groove with the top hook. Then push the cassette in until you hear a click.
- Plug in Motor
Run motor power cord to nearest power outlet. Install wire tie pads and secure with zip ties to hold wire down. The path of the wire should be parallel with mullions and/or drop ceiling tiles ensuring the cable is neatly organized.- To reduce the risk of electric shock, this equipment has a grounding type plug, that has a third (grounding) pin.
- This plug will only fit into a grounding type outlet. If the plug does not fit into the outlet, contact a qualified electrician to install the proper outlet.
- Do not change the plug in any way.
- Do not use an extension cord. If the power supply is too short, have a licensed electrician install an outlet near the drapery operator.
WARNING: Failure to wire as instructed may cause personal injury or damage to device or equipment.
- 12101 Madera Way Riverside, CA 92503
- Phone: 888-245-5077
- Fax: 951-245-5075
- www.rollashade.com
© Copyright 2025 Roll A Shade® Inc., All rights reserved. – Contractor #916075
FAQ
Q: What should I do if the screws do not secure into a stud during installation?
A: Use the supplied drywall anchors to secure the cassette holders in place.
Q: How many screws should be used in each bracket during installation?
A: There must be at least two screws in every bracket to ensure proper installation and stability.
Documents / Resources
 |
ROLL A SHADE RASCP4CMVER.1 Assembled Cassette with Shade [pdf] Installation Guide RASCP4CMVER.1 Assembled Cassette with Shade, RASCP4CMVER.1, Assembled Cassette with Shade, Cassette with Shade, Shade |