Roll A Shade - Commercial Window Shade Solutions
Installation Guide for ROLL A SHADE models including: RASCP4CMVER.1 Assembled Cassette with Shade, RASCP4CMVER.1, Assembled Cassette with Shade, Cassette with Shade, Shade
File Info : application/pdf, 2 Pages, 500.63KB
DocumentDocument12101 Madera Way Riverside, CA 92503 Phone: 888-245-5077 Fax: 951-245-5075 www.rollashade.com RAS - Installation Instructions Contract Plus+ Shade 4" Cassette Motorized UL Hardware Included Tools Required Assembled Cassette with Shade Cassette Holder ¼" x 1" Wood Screws (If requested) ¼" x " Self Tapping Screws Remote (Optional) Repeater (Optional) Drywall Anchors Wire Tie Kit Shade 1 Shade 2 Shade 3 STOP Wall Switch (Optional) Wall Switch (Optional) 1/4" Hex Head Phillips Head Drill 1. Install Cassette Holders Install one cassette holders at each end and the rest spaced evenly across the shade. The edge holder should be as close to the edge as possible and no more than 6" from the edge. Then, install double bearing pin end bracket. Make sure ALL holders are level. Note: If screws do not secure into stud, use supplied drywall anchors. Note: Must be at least two screws in every bracket < 90" = 3 holders > 90" = 4 holders 6" 6" TOP 2. Install Cassette Take assembled cassette and line up the top groove with the top hook. Then push the cassette in until you hear a click. BACK Spacing for Holders www.rollashade.com © Copyright 2025 Roll A Shade® Inc., All rights reserved. - Contractor #916075 RASCP4CMVER.1 Page 1 of 2 3. Plug in Motor Run motor power cord to nearest power outlet. Install wire tie pads and secure with zip ties to hold wire down. The path of the wire should be parallel with mullions and/or drop ceiling tiles ensuring the cable is neatly organized. · To reduce the risk of electric shock, this equipment has a grounding type plug, that has a third (grounding) pin. · This plug will only fit into a grounding type outlet. If the plug does not fit into the outlet, contact a qualified electrician to install the proper outlet. · Do not change the plug in any way. · Do not use an extension cord. If the power supply is too short, have a licensed electrician install an outlet near the drapery operator. WARNING: Failure to wire as instructed may cause personal injury or damage to device or equipment. www.rollashade.com © Copyright 2025 Roll A Shade® Inc., All rights reserved. - Contractor #916075 RASCP4CMVER.1 Page 2 of 2