Where can I find replacement HEPA filters for the Shark DuoClean UV700 series?
For the Shark DuoClean UV700 series (such as the UV725), replacement parts including HEPA filters can be found through the following sources: Official Shark…
Manuals+ Q&A
Shark Duoclean Vacuum Clean Manual — questions & answers
Read product questions and troubleshooting answers linked to Shark Duoclean Vacuum Clean Manual.
Browse topics
Answered questions
How do I charge my Shark DuoClean vacuum?
Based on the manual for the Shark DuoClean NZ801UK Series, this specific model is a corded electric vacuum and does not have a battery…
Why is the green light on the roller section of my Shark DuoClean vacuum on when there are no blockages?
On Shark DuoClean vacuums, a solid green light on the floor nozzle is actually a positive indicator. It signifies that the brushrolls are spinning…
How do I download the full instruction manual and how do I open the upper lid to remove hair from the brushroll?
You can download the manual for the Shark DuoClean (NZ801UK Series) by clicking the Shark-Duoclean-Vacuum-Clean-Manual link located in the post content above. If the…
How do I remove the base of the floor nozzle after unlocking the three locks?
After using a coin to unlock the 3 locks (turn nuts) on the bottom of the floor nozzle, a portion of the base is…
Why is my Shark DuoClean vacuum spitting out dirt even though the roller light is green and there are no obvious blockages?
If your Shark DuoClean is spitting out dirt while the indicator light is green (meaning the brushrolls are spinning correctly), the issue is likely…
What causes an intermittent red light on the brush roll indicator of the Shark DuoClean NV801?
A solid red light on the brush roll indicator typically signifies that the brush roll has stopped spinning due to a blockage or a…
How do I disassemble the handle or check for blockages in the hose of the Shark DuoClean vacuum?
To clear a blockage in the hose or handle of your Shark DuoClean (NZ801UK Series), follow these steps to inspect the airway: Detach the…
How do I reattach the Lift-Away pod to the main vacuum body?
To reattach the Vacuum Pod (the Lift-Away part) to the main unit, follow these steps based on the Shark DuoClean manual: Alignment: Hold the…
How do I reattach the Lift-Away pod to the main vacuum body?
To reattach the Vacuum Pod (the Lift-Away part) to the main vacuum, follow these steps based on the Shark DuoClean manual: Alignment: Hold the…
Why are the rollers not rotating and the headlights flashing on my Shark DuoClean, and why is there low suction at the base?
Flashing headlights and non-rotating brushrolls typically indicate a blockage in the floor nozzle or a brushroll obstruction that has triggered the motor's safety shut-off.…
Why is there no suction through the floor attachment after switching to Lift-Away mode?
If you have switched to Powered Lift-Away™ mode and lost suction at the floor nozzle, please check the following connections and potential blockages: Check…
How can I fix the floor nozzle head on my Shark DuoClean Lift-Away if it won't stay locked in the upright position?
The issue you are describing usually involves the locking mechanism or the pivot joint on the floor nozzle. While the manual does not provide…
Why has my Shark DuoClean Powered Lift-Away stopped working even though the lights are still on?
If your Shark DuoClean's lights are on but the vacuum is not running or picking up debris, it usually indicates a motor overheat, a…
How do I clean the filter?
To clean the filter of your Shark Duoclean Vacuum Cleaner, follow these steps: 1. Rinse the filters under running water. Do not use soap…