GUARD Deadbolt Lock
Installation Guide

WHAT’S INCLUDED

Bolt and strike	Exterior Assembly	Interior Assembly	Screws

What you’ll need
Phillips head Screwdriver
Note: No drill needed

PRODUCT OVERVIEW

EXPLOSIVE VIEW

Adjust the backset of latch (if needed)
A Hold the bolt in front of the door hole, with the latch face flush against door edge.B If the bolt holes are centered in the door hole, no adjustment is required. Proceed to step 2. If the bolt holes are NOT centered, adjust latch. See “bolt Adjustment.”C Latch adjustment t (only if needed)Install BoltInstall front panelConnect wire connectorNote: Cable goes below deadbolt,The wire connectors can only be connected in one way.
Install back panelInstall batteries and battery coverAdjust lock directionNote : If Left handle open door : Choose *46# 123456# 1
If right handle open door: Choose :*46#123456#2 After choose ,input 123456# to check if lock unlock properly.
Insert the key and test the installation

Port Security System LLC
For any technical questions or support call us on: 800 – 219 – 2366
or email us on Authority@portsmartlock.com
Visit us at: www.portsmartlock.com

Documents / Resources

PORT GUARD Deadbolt Lock [pdf] Installation Guide GUARD Deadbolt Lock, GUARD, Deadbolt Lock, Lock

References

• User Manual