nVent HOFFMAN F44WPFG Converting Closure Plate To Reducer
Product Information
The product described in the user manual is a closure plate that can be converted into a reducer. The reducer is used in conjunction with a 4×4 wireway flange, a 4×4 gasket, a 6×6 wireway flange, and a 6×6 gasket.
The closure plate needs to be modified by adding a center cutout and four countersunk holes as shown in Figure 1. The reducer, 4×4 gasket, and 4×4 wireway flange should be connected together as shown in Figure 2. Additionally, the 6×6 wireway flange and 6×6 gasket should be connected to the reducer as shown in Figure 2.
Product Usage Instructions
- Take the closure plate and add a center cutout and four countersunk holes according to the dimensions shown in Figure 1.
- Take the reducer and align it with the 4×4 wireway flange. Attach the 4×4 gasket between the reducer and the flange.
- Attach the 6×6 wireway flange to the other end of the reducer.
- Place the 6×6 gasket between the 6×6 wireway flange and the reducer.
- Ensure all connections are secure and properly aligned.
Make sure to refer to the figures mentioned in the instructions for a visual representation of how the components should be connected.
Assembly Instruction
- Modify closure plate by adding center cutout and four countersunk holes as shown in Fig. 1.
- Connect reducer and 4×4 gasket to 4×4 wireway flange as shown in Fig. 2.
- Connect 6×6 wireway flange and 6×6 gasket to reducer as shown in Fig. 2.
© 2018 Hoffman Enclosures Inc.
- PH 763 422 2211
- nVent.com/HOFFMAN
- 87568877
- P/N 99401151
Documents / Resources
 |
nVent HOFFMAN F44WPFG Converting Closure Plate To Reducer [pdf] Instructions Untitled, F44WPFG, F44WPFG Converting Closure Plate To Reducer, Converting Closure Plate To Reducer, Closure Plate To Reducer, Plate To Reducer, Reducer |