n-com SPCOM00000027 Right Cable Instruction Manual

n-com SPCOM00000027 Right Cable Instruction

INSTRUCTIONS FOR REPLACING THE SPCOM00000027

1. Remove the N-Com system from the helmet (see instruction booklet).
2. Open the e-box (Fig. 1-2).
3. If necessary, disconnect the antenna connector (Fig. 3-4).
4. Remove the wiring to be replaced and position the new wiring connector in the counterpart on the electronic card (Fig. 5).
5. If previously removed, reconnect the antenna to the card.
6. Close the e-box (Fig. 6-7).
7. Reposition the N-Com system inside the helmet (see instruction booklet).