Dynamic-Biosensors-logo

Dynamic Biosensors helix cyto Normalization Solution

Dynamic-Biosensors-helix-cyto-Normalization-Solution-product

സ്പെസിഫിക്കേഷനുകൾ

  • ഉൽപ്പന്നത്തിൻ്റെ പേര്: heliX cyto Normalization Solution (Red Dye)
  • ഓർഡർ നമ്പർ: NOR-R2
  • For scIC measurements in the red channel
  • ഗവേഷണ ഉപയോഗത്തിന് മാത്രം
  • Limited shelf life – please check expiry date on label

പ്രധാന സവിശേഷതകൾ

  • ഒരു ഹെലിക്സൈറ്റോ ചിപ്പിൻ്റെ സ്പോട്ട് 1, സ്പോട്ട് 2 എന്നിവയിലെ ഫ്ലൂറസെൻ്റ് സിഗ്നലുകളുടെ നോർമലൈസേഷനായി
  • Enables correct real-time referencing of the red fluorescent signals during scIC measurements
  • Compatible with all heliXcyto chips
  • The Normalization solution (red dye) contains a hydrophilic red dye with a single negative net charge.

ഉൽപ്പന്ന വിവരണം

  • ഓർഡർ നമ്പർ: NOR-R2

പട്ടിക 1. ഉള്ളടക്കവും സംഭരണ ​​വിവരങ്ങളും

മെറ്റീരിയൽ തൊപ്പി ഏകാഗ്രത തുക സംഭരണം
Normalization solution-R2 ചുവപ്പ് 10 µM 6x 100 µL -20 ഡിഗ്രി സെൽഷ്യസ്
  • ഗവേഷണ ഉപയോഗത്തിന് മാത്രം.
  • This product has a limited shelf life; please see the expiry date on the label.
  • To avoid many freeze-thaw cycles, please aliquot the solution.

തയ്യാറാക്കൽ

  • Use this red dye normalization solution for scIC measurements in the red channel (analyte label-dependent).
  • Dilute the 10 µM normalization stock solution to a working concentration with running buffer.
  • The concentration of the normalization solution should approximately correspond to the fluorophore concentration in the highest analyte concentration to be measured. This can be calculated usingthe  following equation:

Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-1

  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-3 Concentration of the normalization solution in the desired color :
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-4ലേബൽ ചെയ്ത അനലിറ്റ് ലായനിയിൽ ഡൈയുടെ സാന്ദ്രത
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-5Highest concentration of the analyte that should be measured
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-6Degree of labeling (ratio of dye to analyte)

നേർപ്പിച്ച ലായനികൾ 2-8 ഡിഗ്രി സെൽഷ്യസിൽ 7 ദിവസം വരെ സൂക്ഷിക്കാം.

അപേക്ഷാ കുറിപ്പ്
In the scIC measurement, the fluorescent signal of the normalization solution should be in a similar range to the highest signal coming from the bound analyte (raw data). The absolute fluorescent signal is dependent on normalization solution concentration and the excitation power applied in the measurement. The excitation power has to be selected based on the following parameters:

  • Fluorophore concentration inthe  analyte solution
    ഫ്ലൂറോഫോർ കോൺസൺട്രേഷൻ അളവെടുപ്പിൽ ഉപയോഗിക്കുന്ന അനലൈറ്റ് കോൺസൺട്രേഷനെയും അനലൈറ്റിൻ്റെ ലേബലിംഗിൻ്റെ അളവിനെയും ആശ്രയിച്ചിരിക്കുന്നു. ഉയർന്ന DOL, ഉയർന്ന വിശകലന സാന്ദ്രത എന്നിവയ്ക്ക്, ഉത്തേജക ശക്തി കുറയ്ക്കേണ്ടത് ആവശ്യമായി വന്നേക്കാം.
  • പ്രതീക്ഷിക്കുന്ന ബൈൻഡിംഗ് സിഗ്നൽ
    Highly expressed targets on a cell can bind more molecules of the labeled analyte. In case of highly overexpressed targets, a strong binding signal can be expected. To avoid the shutter closing, lowering the excitation power might be considered.
  • ചിപ്പ് തരം
    വ്യത്യസ്ത ചിപ്പ് തരങ്ങൾക്ക് വ്യത്യസ്ത ഫ്ലൂറസെൻ്റ് പശ്ചാത്തലങ്ങളുണ്ട്. വലിയ കെണികളും ചിപ്പിൽ കൂടുതൽ കെണികളും, പശ്ചാത്തല സിഗ്നൽ ഉയർന്നതാണ്. അതിനാൽ, L5 ചിപ്പുകൾക്ക് M5 ചിപ്പുകളിൽ പ്രയോഗിക്കുന്നതിനേക്കാൾ കുറഞ്ഞ ആവേശം ആവശ്യമായി വന്നേക്കാം.

For a starting point of excitation power and normSolution on concentration to be used in an scIC experiment, please refer to Table 2.
Table 2. Relation of fluorophore concentration, normalization solution concentration, and excitation power suitable for an Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-2 M5 ചിപ്പ്

അനലിറ്റ് ഡൈ കോൺസി. = വിശകലനം കോൺക് x DOL ഉത്തേജന ശക്തി ഏകാഗ്രത നോർമലൈസേഷൻ പരിഹാരം നേർപ്പിക്കൽ നോർമലൈസേഷൻ പരിഹാരം
25 എൻഎം 0.5 25 എൻഎം 1:400
50 എൻഎം 0.3 50 എൻഎം 1:200
100 എൻഎം 0.2 100 എൻഎം 1:100
300 എൻഎം 0.1 300 എൻഎം 1:33
500 എൻഎം 0.08 500 എൻഎം 1:20
1 µM 0.05 1 µM 1:10
2.5 µM 0.02 2.5 µM 1:4

കുറിപ്പ്: This table is for your guidance. However, the final signal recorded in the heliXcyto depends on many factors. Thus, some optimization will be required for each system.

ബന്ധപ്പെടുക

ഡൈനാമിക് ബയോസെൻസറുകൾ GmbH
Perchtinger Str. 8/10 81379 Munich, Germany

ബ്രൂക്കർ സയന്റിഫിക് എൽഎൽസി
40 മാനിംഗ് റോഡ്, മാനിംഗ് പാർക്ക്, ബില്ലെറിക്ക, MA 01821 USA

www.dynamic-biosensors.com
ഉപകരണങ്ങളും ചിപ്പുകളും ജർമ്മനിയിലാണ് എഞ്ചിനീയറിംഗ് ചെയ്ത് നിർമ്മിക്കുന്നത്. ©2025 ഡൈനാമിക് ബയോസെൻസറുകൾ GmbH ഗവേഷണ ഉപയോഗത്തിന് മാത്രം. ക്ലിനിക്കൽ ഡയഗ്നോസ്റ്റിക് നടപടിക്രമങ്ങളിൽ ഉപയോഗിക്കാനുള്ളതല്ല.

പതിവുചോദ്യങ്ങൾ

What is the shelf life of the heliX cyto Normalization Solution?

ഉൽപ്പന്നത്തിന് പരിമിതമായ ഷെൽഫ് ലൈഫ് ഉണ്ട്. നിർദ്ദിഷ്ട വിവരങ്ങൾക്ക് ലേബലിൽ കാലഹരണപ്പെടൽ തീയതി പരിശോധിക്കുക.

How should I store the NOR-R2 v1.0 product?

The product should be stored according to the storage information provided in Table 1 of the user manual.

Can I use this product for clinical purposes?

No, this product is for research use only.

പ്രമാണങ്ങൾ / വിഭവങ്ങൾ

Dynamic Biosensors helix cyto Normalization Solution [pdf] ഉപയോക്തൃ മാനുവൽ
helix cyto Normalization Solution, helix cyto, Normalization Solution, Solution

റഫറൻസുകൾ

ഒരു അഭിപ്രായം ഇടൂ

നിങ്ങളുടെ ഇമെയിൽ വിലാസം പ്രസിദ്ധീകരിക്കില്ല. ആവശ്യമായ ഫീൽഡുകൾ അടയാളപ്പെടുത്തി *