MEAN WELL LPF-16-12 Constant Voltage Constant Current LED Driver Installation Guide

LPF-16 series is a 16W AC/DC LED driver featuring the dual modes constant voltage and constant current output. LPF-16 operates from 90 ~ 305VAC and offers models with different rated voltage ranging between 12V and 54V. Thanks to the efficiency up to 86%, with the fanless design, the entire series is able to operate for -35°C ~ +70°C case temperature under free air convection. The entire series is suitable to work for a variety of applications at dry or damp locations and the optional models with IP67 rating is able to further work at wet locations.

Model Encodina

SPECIFICATION

MODEL

LPF-16-12

LPF-16-15

LPF-16-20

LPF-16-24

LPF-16-30

LPF-16-36

LPF-16-42

LPF-16-48

LPF-16-54

OUTPUT

DC VOLTAGE

12V

15V

20V

24V

30V

36V

42V

48V

54V

CONSTANT CURRENT REGION Note.2

6.6 ~12V

8.25 ~ 15V

11 ~ 20V

13.2 ~ 24V

16.5 ~ 30V

19.8 ~ 36V

23.1 ~ 42V

26.4 ~ 48V

29.7 ~ 54V

RATED CURRENT

1.34A

1.07A

0.8A

0.67A

0.54A

0.45A

0.39A

0.34A

0.3A

RATED POWER Note.5

16.08W

16.05W

16W

16.08W

16.2W

16.38W

16.32W

16.2W

RIPPLE & NOISE (max.) Note.3

150mVp-p

200mVp-p

250mVp-p

350mVp-p

VOLTAGE TOLERANCE Note.4

±4.0%

LINE REGULATION

±0.5%

LOAD REGULATION

±2.0%

±1.5%

±1.0%

±0.5%

SETUP, RISE TIME Note.6

1500ms, 80ms / 115VAC 500ms, 80ms / 230VAC

HOLD UP TIME (Typ.)

16ms/230VAC 16ms /115VAC

INPUT

VOLTAGE RANGE Note.5

90 ~ 305VAC 127 ~ 431VDC

(Please refer to “STATIC CHARACTERISTIC” section)

FREQUENCY RANGE

47 ~ 63Hz

POWER FACTOR

PF≧0.97/115VAC, PF≧0.95/230VAC, PF≧0.92/277VAC@full load

(Please refer to “POWER FACTOR (PF) CHARACTERISTIC” section)

TOTAL HARMONIC DISTORTION

THD< 20%(@load≧60%/115VC,230VAC; @load≧75%/277VAC)

(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)

EFFICIENCY (Typ.)

84%

86%

AC CURRENT

0.4A / 115VAC 0.25A / 230VAC 0.2A/277VAC

INRUSH CURRENT(Typ.)

COLD START 45A(twidth=200μs measured at 50% Ipeak) at 230VAC; Per NEMA 410

MAX. No. of PSUs on 16A CIRCUIT BREAKER

14 units (circuit breaker of type B) / 24 units (circuit breaker of type C) at 230VAC

LEAKAGE CURRENT

<0.75mA / 240VAC

PROTECTION

OVER CURRENT

95 ~ 108%

Constant current limiting, recovers automatically after fault condition is removed

SHORT CIRCUIT

Hiccup mode, recovers automatically after fault condition is removed

OVER VOLTAGE

15 ~ 18V

17.5 ~ 21V

23 ~ 27V

28 ~ 35V

34 ~ 40V

41 ~ 49V

46 ~ 54V

54 ~ 63V

59 ~ 66V

Shut down and latch off o/p voltage, re-power on to recover

OVER TEMPERATURE

Shut down o/p voltage, recovers automatically after temperature goes down

ENVIRONMENT

WORKING TEMP.

Tcase=-35 ~ +70℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)

MAX. CASE TEMP.

Tcase=+70℃

WORKING HUMIDITY

20 ~ 95% RH non-condensing

STORAGE TEMP., HUMIDITY

-40 ~ +80℃, 10 ~ 95% RH

TEMP. COEFFICIENT

±0.03%/℃ (0 ~ 50℃)

VIBRATION

10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes

SAFETY & EMC

SAFETY STANDARDS Note.8

UL8750, CSA C22.2 No. 250.0-08; ENEC BS EN/EN61347-1, BS EN/EN61347-2-13 independent, BS EN/EN62384,J61347-1,

J61347-2-13,EAC TP TC 004,GB19510.1,GB19510.14 approved,IP67 (optional) ; Design refer to UL60950-1

WITHSTAND VOLTAGE

I/P-O/P:3.75KVAC

ISOLATION RESISTANCE

I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH

EMC EMISSION Note.8

Compliance to BS EN/EN55015,BS EN/EN61000-3-2 Class C (@load≧50%) ; BS EN/EN61000-3-3,GB/T 17743 , GB17625.1, EAC TP TC 020

EMC IMMUNITY

Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11; BS EN/EN61547, light industry level (surge immunity Line-Line 2KV),EAC TP TC 020

OTHERS

MTBF

3572.8K hrs min. Telcordia SR-332 (Bellcore) ; 427.3K hrs min. MIL-HDBK-217F (25℃)

DIMENSION

148*40*32mm (L*W*H)

PACKING

0.21Kg; 40pcs/9.4Kg/1.02CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25℃ of ambient temperature.

2. Please refer to “DRIVING METHODS OF LED MODULE”.

3. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

4. Tolerance : includes set up tolerance, line regulation and load regulation.

5. De-rating may be needed under low input voltages. Please refer to “STATIC CHARACTERISTIC” sections for details.

6. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.

7. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.

(as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf)

8. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch without permanently connected to the mains.

9. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 70℃ or less.

10. Please refer to the warranty statement on MEAN WELL’s website at http://www.meanwell.com

11. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).

12. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf

※ Product Liability Disclaimer：For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx

BLOCK DIAGRAM

DRIVING METHODS OF LED MODULE

This series is able to work in either Constant Current mode (a direct driveway) or Constant Voltage mode (usually through additional DC/DC driver) to drive the LEDs.

OUTPUT LOAD vs TEMPERATURE

STATIC CHARACTERISTIC

POWER FACTOR (PF) CHARACTERISTIC

TOTAL HARMONIC DISTORTION (THD)

48V Model, Tcase at 60℃

EFFICIENCY vs LOAD

LPF-16 series possess superior working efficiency that up to 86% can be reached in field applications.

48V Model, Tcase at 60°C

LIFE TIME

MECHANICAL SPECIFICATION

CASE NO.: LPF-16A Unit:mm Tolerance:±1

Recommend Mounting Direction

INSTALLATION MANUAL

Please refer to:http://www.meanwell.com/manual.html

Documents / Resources

MEAN WELL LPF-16-12 Constant Voltage Constant Current LED Driver [pdf] Installation Guide
LPF-16-12, LPF-16-15, LPF-16-20, LPF-16-24, LPF-16-30, LPF-16-12 Constant Voltage Constant Current LED Driver, LPF-16-12, Constant Voltage Constant Current LED Driver, Voltage Constant Current LED Driver, Constant Current LED Driver, Current LED Driver, LED Driver, Driver

References

User Manual

MEAN WELL LPF-16-12 Constant Voltage Constant Current LED Driver

Frequently Asked Questions

Features

Applications

GTIN CODE

Description