MASTERBUILT MB20041223 Controller Module Kit

Product Specifications

• Product Name: Controller Module kit, GSGXT
• Model Numbers: MB20041223, MB20043024

CAUTION

• Always remove plug from outlet before servicing your grill.
• Make sure your grill has fully cooled to avoid burns.
• Some components may have sharp edges. Use caution to avoid injury.

Note: Your grill may vary from images shown

Installation Instruction

Note: Your grill may vary from images shown

1. Unscrew the shutdown flap handle.
2. Remove 3 screws on the small hopper shroud. Remove the shroud.
3. Remove the controller connections.
4. Remove the 4 thumb screws from the back of the controller. Remove the controller.
5. Disconnect two black and white wire connections on the side of the controller.
6. Loosen 3 screws on the insulation housing to make room for the power plug.
7. Remove 6 screws from rear of controller and remove the back panel .
8. Disconnect 2 wire connections and feed the controller wire through the hopper pass through holes. Note, you will have to remove a zip tie from the inside of the hopper .
9. Attach the antenna to the new controller. Rotate the antenna on the base.

Finish the controller reinstall by following all steps in reverse.

Frequently Asked Questions

Q: Can I use this Controller Module kit on any grill?
A: The compatibility of this kit may vary, it is recommended to check with the manufacturer for specific grill compatibility.

Q: Are there any precautions to consider while handling the controller module?
A: Ensure proper disconnection of power sources before handling the controller module to prevent electrical hazards.

Documents / Resources

MASTERBUILT MB20041223 Controller Module Kit [pdf] Installation Guide MB20041223, MB20043024, MB20041223 Controller Module Kit, Controller Module Kit, Module Kit

References

• User Manual