MASTERBUILT G2 Bottom Hopper Replacement Instructions

MASTERBUILT logo MASTERBUILT G2 Bottom Hopper Replacement

G2 Bottom Hopper Replacement

Bottom Hopper Replacement, 2 Piece Hopper, Gravity Series (G2)
CAUTION

  • Always remove plug from outlet before servicing your grill.
  • Make sure your grill has fully cooled to avoid burns.
  • Some components may have sharp edges. Use caution to avoid injury.

Note: Your grill may vary from images shownMASTERBUILT G2 Bottom Hopper Replacement - assembly 1Remove the fan from the lower housing, you will reuse. MASTERBUILT G2 Bottom Hopper Replacement - assembly 2Remove the shutdown slides, charcoal grate and remove all charcoal from the hopper. MASTERBUILT G2 Bottom Hopper Replacement - assembly 3Remove the bottom hopper shroud and hopper door. MASTERBUILT G2 Bottom Hopper Replacement - assembly 4Remove the 6 screws from the bottom of the hopper plate. MASTERBUILT G2 Bottom Hopper Replacement - assembly 5Remove the 2 screws and nuts from lower hopper mounting bracket.MASTERBUILT G2 Bottom Hopper Replacement - assembly 6Replace hopper. Replace the gaskets Replace the fan. Reconnect wires.

MASTERBUILT logoFor reinstallation, follow all steps in reverse.
601813 240116-GH

Documents / Resources

PDF thumbnailG2 Bottom Hopper Replacement
Instructions · G2 Bottom Hopper Replacement, G2, Bottom Hopper Replacement, Hopper Replacement, Replacement

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.