Manage Engine Connect and Control Devices via USB Software User Guide

Connect and control devices via USB

1. Open AtomStack Studio software and click the “Add Device” button.
   
2. Connect engraver to the computer through equipped USB cable and click
   “Next”. Please check followings in case of connection failure:
   1. Please check whether the device and computer serial port are working properly. You can try other serial ports.
   2. If you simultaneously connect to other software (e.g., Light burn) while using the current device, please close other similar software.
   3. The computer USB driver version is out of date, please update it:
      Windows driver: https://asa.atomstack.com/downloadWindowsDrivers.do3.
      Mac driver: https://asa.atomstack.com/downloadMacDrivers.do3.
      
3. Select correct model and click “Next Step”
   
4. The device is added successfully, now start your creation.
   

Documents / Resources

ManageEngine Connect and Control Devices via USB Software [pdf] User Guide Connect and Control Devices via USB Software, Software

References

• User Manual