SEBSON Outdoor LED Light

Intended Use

This SEBSON outdoor light is suitable for indoor and outdoor installation.

Scope of Delivery

• 1 Outdoor light
• Screws for fixing (3 pieces)
• Dowels Ø 6mm (3 pieces)

General Safety Instructions

⚠️ Danger: Installation must be performed by a qualified professional according to applicable electrical and installation regulations.

⚠️ Danger: If the product is damaged or comes into contact with moisture, immediately disconnect power and ensure it cannot be switched on again.

? Attention - Suffocation Hazard: Keep this product away from children and animals. Packaging contains small parts that can be swallowed.

?️? Caution: To prevent fire or eye damage, never direct the light beam directly at people or animals, and avoid looking directly into the light source.

• The built-in light source cannot be replaced.
• Modification of this product is not permitted. This will invalidate the warranty and compromise safe operation.
• Do not connect a dimmer, as it may damage the lamp.
• Do not cover the light with heat-insulating materials, as excessive heat can damage the LEDs.
• The manufacturer is not liable for injuries or damage resulting from improper use.
• Any use other than described may result in product damage, including electric shock, short circuit, or fire.
• Changes to the product, packaging, or instructions, as well as printing errors, are reserved.
• This product is suitable for indoor and outdoor use.
• Protect the product from external damage, heavy dirt, moisture, and excessive heat.
• To maintain warranty, use only supplied parts. Repairs must be done by an expert using original spare parts.
• In commercial facilities, accident prevention regulations for electrical installations must be followed.

Installation Instructions (Fig. 2)

General Precautions:

• Ensure the power circuit is interrupted before installation. Work on mains voltage requires a qualified person. Remove the fuse or deactivate the switch and verify the line is de-energized with a voltage tester. The circuit must not be closed during installation (danger of death).
• Before drilling mounting holes, ensure there are no gas, electricity, or water pipes at the drilling location that could be damaged.
• Always observe safety instructions and technical data before mounting.

Wiring:

• L: Live wire (black or brown)
• N: Neutral conductor (blue or grey)

Diagram Description: Figure 2 illustrates the mounting process. It shows steps involving securing the mounting bracket, connecting wires, and attaching the light fixture. Specific numbered steps in the original diagrams are implicitly covered by the textual description of the process.

Technical Data

This product contains a light source of energy efficiency class G.

Information for Private Households (WEEE)

The Electrical and Electronic Equipment Act (WEEE) sets requirements for handling electrical and electronic equipment. Key points include:

1. Separate Collection of Waste Equipment: Old, worn-out, or defective equipment must not be disposed of with normal household or residual waste. It should be transferred to special collection and return systems.
2. Batteries, Rechargeable Batteries, and Illuminants: Spent batteries, accumulators, and light sources that can be removed without damage must be separated from the main equipment before handing it over to a collection point. Batteries containing harmful substances are marked with a crossed-out bin symbol (?️) and chemical names (e.g., "Cd" for cadmium, "Pb" for lead, "Hg" for mercury). Improper disposal can cause health and environmental hazards; separate collection and proper disposal avert these risks.
3. Options for Returning Old Appliances: Owners can return old appliances free of charge at public waste management collection points or manufacturer/distributor take-back points.
4. Data Privacy Notice: Old devices may contain sensitive personal data. End-users are responsible for deleting data from devices before disposal.
5. Meaning of the "Crossed-out Dustbin" Symbol: This symbol indicates that the device must be collected separately from unsorted municipal waste at the end of its service life.

Cleaning Instructions

⚠️ Danger: Before cleaning, interrupt the circuit by switching off the breaker or removing the fuse.

• Use a slightly moistened cloth for cleaning.
• To prevent product damage, avoid water ingress into the housing.
• Never clean the device under running water.
• Do not use solvent-containing cleaners.

Contact Information

SEBSON
Sebastian Sonntag
Walter-Behrendt-Str.10
44329 Dortmund
Germany

Email: support@sebson.de

VAT ID: GB179436663 (DE246981805, FR95821175288, ESY4306459E, IT00171519994, PL5263171411)

WEEE Registration Numbers: DE 78960174, DE 4848624667044, DE 11339413 (Batteries Reg. No.), IT19060000011454 (Eco-contributo RAEE)