Product Description
Dr. Brown's Milestones™ soft silicone sippy spout and sippy bottle are designed to help your child transition from bottle to cup. The sippy spout can also be used in place of the nipple/teat on Dr. Brown's Options+™ Bottles when the internal vent system has been removed. The sippy spout will not work properly with the vent system installed, or in non-Dr. Brown's Options+ Bottles.
Important Instructions
Read and save these instructions for future use.
Before First Use and Each Use
Before first use, fully disassemble all parts, wash the product, then place the components in boiling water for five minutes to ensure hygiene. To prevent a possible choking hazard, pull on the spout in all directions before each use to ensure it does not tear. Inspect carefully, especially when the child develops teeth. Discontinue use and replace the spout immediately if any signs of wear or damage are visible, such as cracking or change of shape. Small pieces can accidentally be inhaled and cause serious injury.
Cleaning
Fully disassemble all parts and wash prior to each use. The spout must be clean and free of obstructions. All parts are safe for use in a dishwasher (top rack only), electric sterilizer, microwave sterilizer, or boiling water.
Sippy Bottle Assembly
Insert sippy spout from the bottom side of the collar and pull the spout from the top until it snaps into place. Fill the bottle for feeding and tighten the collar with spout onto the bottle. If your sippy bottle has Dr. Brown's Silicone Handles, place the bottle on a firm surface. Start the handles at the top and apply downward pressure to both handles at the same time. Adjust the handles until they are at the desired height. To remove, place the bottle in soapy water and carefully slide the handles off. When transporting bottles, always keep them upright with the cap on to help prevent leaking.
Safety Warnings
- Continuous and prolonged sucking of fluids will cause tooth decay.
- Always check food temperature before feeding.
- Throw away at the first signs of damage or weakness.
- Keep components not in use out of the reach of children.
- Never attach to cords, ribbons, laces, or loose parts of clothing. The child can be strangled.
- Never use the sippy spout as a pacifier/soother.
- Always use this product with adult supervision.
- Always check the spout for signs of wear and replace when damaged.
- Do not use a microwave oven to heat the bottle as microwave ovens can create hotspots in milk/formula and/or bottle components.
- Do not leave the spout in direct sunlight, heat, or in sterilizing solution for longer than recommended as this may weaken the spout.
- Do not allow a child to walk or run while using any bottle.
- Do not let a child take a bottle to bed or self-feed for long periods.
